Electronics Forum | Tue Oct 29 15:55:16 EST 2002 | babe
If you are using a low end hot air system IE: Weller, Hakko or Pace then your problems are with the system and not necessarily with your process. However process is important. We have found by inspection with an Ersa Scope (BGA inspection system) tha
Electronics Forum | Wed Nov 14 20:30:26 EST 2001 | davef
Tks. So was the answer that you got close? [ala "Car Talk"] Some guy from Cal-fornie sends me spill. I get cigars from � Yeh, I know I hog the responses, but I learn by doing this. If I can communicate in print, I can better communicate in word
Electronics Forum | Sat Aug 03 01:40:24 EDT 2019 | sarason
I own a metcal for the high precision work 1500$ in 1992 tips $60 in 1992 and have only used one tip in all that time, have horses holves for large pin devices, precision points for 0402 and a largest tip for service work. Also have Hakkos for bulk
Electronics Forum | Thu Jan 07 16:46:05 EST 1999 | Steve Gregory
Hey ya'll!! SUCCESS! I was able to get that monster off!...(Now I just gotta' be able to get it back on right...hehehe) If you remember, the whole reason I had to rework it was because somehow they got the hole positions wrong in the board for
Electronics Forum | Sun Apr 25 19:03:13 EDT 1999 | Steve Gregory
| Again, I know this does not answer your needs. I do believe there to be a cheaper system than ours that will satisfy your needs. Big Steve found one that seems fairly reasonable for less damandig boards than ours. | | Earl Moon Hi Joe! Yeah Earl
Electronics Forum | Tue Aug 17 10:32:19 EDT 1999 | Boca
| | | | Ladies and Gentlemen, | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I wou
Electronics Forum | Tue Aug 17 10:35:52 EDT 1999 | Boca
| | | | | Ladies and Gentlemen, | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows
Electronics Forum | Tue Aug 17 10:48:16 EDT 1999 | Earl Moon
| | | | | | Ladies and Gentlemen, | | | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally f
Electronics Forum | Tue Aug 17 12:34:33 EDT 1999 | John Dwinell
| | | | | | Ladies and Gentlemen, | | | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally f
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
1 |