Electronics Forum | Wed Jan 17 21:40:49 EST 2007 | Sumbi
Oven keeps building up debri in cooling plates and flux system seems not very good. would preferr less maintance,no time. know of any work arounds.Oven is Paragon series.
Electronics Forum | Tue Jan 23 23:28:54 EST 2007 | jovial_guy23
If you have flux deposits on the cooling plates, try out Zestron's VIGON RC101...It is an extremely good product especially for reflow ovens and wave solder systems. Check it out...Minimal maintenance water based chemistry with no flash point...Much
Electronics Forum | Wed Jan 17 22:35:21 EST 2007 | JNet
Is the oven air or nitrogen? If it is air I would suggest more exhuast to pull the flux vapors out if the oven before they can condense in the cooling. If it is a nitrogn machine that makes it a little more complicated. If the filter system is clogge
Electronics Forum | Fri Jun 18 12:51:58 EDT 2004 | JD
Just curious if anyone has had any problems because of using acetone to clean flux off boards or parts. Is acetone an acceptable flux remover for re-work? What are the pros and cons about using acetone Thanks in advance, JD
Electronics Forum | Wed Jun 23 17:56:31 EDT 2004 | Shean Dalton
Acetone is likely not compatible with several component types, the evaporation charactoristics are desirable. IPA is more compatible, though, may not solubilize the residues. Austin American Technology developed MegaSolv JB and MegaSolv NOC for the
Electronics Forum | Thu May 13 20:38:32 EDT 1999 | lima
Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? My concern is the volatiles in my WS629 solder paste may be attacking th
Electronics Forum | Fri Jun 18 13:12:56 EDT 2004 | Cal
we noticed Electroytic caps (Rubber plug), standoffs, and most of the plastic and rubber parts were effected and started to break down. I do not know id the mask material is effected or what residue is left behind ....as we never made it past the 1s
Electronics Forum | Fri Jun 18 13:22:50 EDT 2004 | JD
Out of curiosity, what method did you use? I ask because I have used acetone on a Q-Tip to clean up boards after rework for some time and haven't noticed anything like that. Did you notice it right away? Or after some time went by? I may need to re-
Electronics Forum | Fri May 14 15:03:19 EDT 1999 | lima
| | Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | | | My concern is the volatiles in my WS629 solder paste may be
Electronics Forum | Thu Jun 24 17:13:44 EDT 2004 | davef
Echoing SheanDalton's comments [above in this thread]: * A good way to strip part markings, solder mask, etc. * A fairly aggressive against most polymers. * A flammable material. * VOC issues in its use. * Assembly workers don't like the smell. * A