Electronics Forum | Mon Nov 29 11:47:06 EST 2010 | davef
While you're waiting for others to reply, look here: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=28458
Electronics Forum | Thu Nov 25 17:32:54 EST 2010 | padawanlinuxero
Hello !!! Long time since I was here, I have a problem, I use a Electrovert EPK Plus solder wave to solder 8 leads the pcb is like a inche wide and 3/4 or less of height and the leads their size is .3570 inches long by .0195 wide and .0180inches th
Electronics Forum | Wed Mar 05 04:10:34 EST 2003 | Joseph
Presently, we have one PWBA with Hall IC which required designated PWE-Carrier to hold this component from bottom. This IC only has 4 leads at one at one side, whereas no lead available at the opposite. See below diagram for detail. _____
Electronics Forum | Mon Jul 17 21:56:20 EDT 2006 | davef
Look here: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=39769
Electronics Forum | Mon Jul 17 07:05:10 EDT 2006 | Steve H.
Hi, I was wondering, if there were any guidelines to what %RH the production hall should be running within, and what consequences can occurr, if we are running higher or lower than the reccommendations. I am worried, with regards to the above, as w
Electronics Forum | Sat Mar 18 08:20:47 EST 2000 | Wayne Bracy
Just returned from Long Beach and the APEX 2000 show. It has been a number of years of since I attended a trade show and felt the excitement of being on an exhibit floor. All or at least most of the exhibitors seemed to be very busy and looking
Electronics Forum | Mon Sep 20 18:27:13 EDT 2010 | ratsalad
dman, This happened to me once on a GSX, but the head was not all the way up. I ended up shutting the machine down, inserting a bypass key so it thought the head was lowered then turning it back on. Then I told it I wanted to raise the head, hit
Electronics Forum | Mon Jul 17 11:19:46 EDT 2006 | Chunks
Never seen a direct study on these two correlation�s before. But if you have moisture sensitive devices, higher humidity could have some affect on them. If you are talking regular Rs and Cs over wave solder - I kinda doubt it. Water based fluxes d
Electronics Forum | Tue Jul 05 18:24:50 EDT 2016 | padawanlinuxero
Hi have you try to use some type of adhesive like loctite or a solder mask to avoid lifted components, we use both in 2 different products, we use loctite to avoid a hall inserted in a plastic carrier, lift when being solder in the solder wave, the s
Electronics Forum | Fri Oct 26 06:16:30 EDT 2001 | genglish
I have located an alternative supplier who manufacturers at half the cost of a DEK pump print and has a UK standard 3 day delivery service!!!! Contact Graham Hall or Fraser Shaw Tannlin@compuserve.com (G)
winsouce.jpg)
.gif)
