Electronics Forum | Mon Jun 08 13:26:59 EDT 1998 | D.Hammond
I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot of
Electronics Forum | Mon Jun 08 15:01:02 EDT 1998 | D.Lange
| I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot
Electronics Forum | Mon Jun 08 15:00:08 EDT 1998 | Earl Moon
| I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot
Electronics Forum | Mon Jan 12 09:44:00 EST 2015 | rgduval
Oh yeah, I've seen this before! Generally, if the hole sizes are correct (including plating), and the PEMs are within spec, we've found that this is most commonly caused by insufficient support of the PCB during insertion. If you can eliminate supp
Electronics Forum | Mon Dec 06 04:40:39 EST 1999 | cklau
Halo; In your last message you did not mentioned why your customer need to use IPA to clean PCB's as their requirement and what subtances they want to get rid of (is it flux stain PCB's or component?).If so recommend your value customer of flux 910
Electronics Forum | Wed Jul 28 12:02:48 EDT 1999 | Wolfgang Busko
| | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That wou
Electronics Forum | Wed Jul 28 16:36:30 EDT 1999 | Earl Moon
| | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That w
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
