Electronics Forum | Thu Mar 31 13:48:19 EST 2005 | shannond
Hi All, I have to solder a device with platinum clad nickel leads to a PCB. I am having a hard time getting solder to flow on to the leads. Are there special proceedures that I need to follow because of the platinum or am I just dealing with contamin
Electronics Forum | Wed Jul 31 18:26:09 EDT 2013 | Jeff Kennedy
You might consider to contact a lab to Run a microindenter against a know good soft gold sample. The knoop value for the soft gold will be much lower than for hard gold. This would be reflected in the diameter measurement of the indented samples.Smal
Electronics Forum | Thu May 02 09:33:30 EDT 2013 | 15009
Looking for advice on soldering lead free paste to a board with very heavy gold plating. I have learned from the Customer that this is HARD GOLD and that it is 10-20 Micro Inches Hard Gold over 100 Micro inches of Nickel. When we reflowed the solde
Electronics Forum | Wed Feb 03 16:45:20 EST 1999 | Mark Henebry
Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connector
Electronics Forum | Wed Feb 03 18:36:47 EST 1999 | Earl Moon
| Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connect
Electronics Forum | Wed Feb 03 23:40:26 EST 1999 | Chris G.
| Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connect
Electronics Forum | Fri Feb 24 11:31:20 EST 2012 | pauld
I need to be sure of the Nickel/Hard Gold thickness to be specified on our drawing. We use hard gold on a slip ring pcb that has brushes riding over the conductive surface, so soldering is not the issue. I read through the hard gold vs immersion gold
Electronics Forum | Sat Feb 25 12:00:24 EST 2012 | davef
50 to 75 insertions * 50 uin gold => 300 insertions
Electronics Forum | Wed Dec 28 21:18:12 EST 2005 | davef
You don't TS bond gold wire to nickel [of ENIG] for the same reason that you don't TS bond gold wire to hard gold. [Nickel or maybe cobalt is used to harden soft gold.] Together nickel and gold produce unreliable bonds. Look here: * http://www.smta.
Electronics Forum | Wed Apr 21 17:08:32 EDT 2004 | dave
Congratulations on your new customer. This could be a keeper. Here's what you're familiar with: Electroless Nickel - per MIL-C-26074 and ASTM-B733. Electroless nickel describes the plating of nickel deposits, which may contain phosphorus and boro
