Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Sat Mar 10 08:05:09 EST 2007 | davef
Here's your test definitions [clipped from the dictionary in the fine SMTnet Library]: * Test, Automated. Computer controlled electrical testing of parts, assemblies, or finished products. * Test, Built-In (BIT). An electrical testing technique whi
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Tue Jan 10 16:01:20 EST 2017 | davef
A review document for J-STD-001F with Amendment 1 had the following wording, but you should check the actual document to be sure of correctness 4.2 Facilities Cleanliness and ambient environments in all work areas shall [D1D2D3] be maintained at le
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Tue Jun 11 15:56:43 EDT 2002 | mjabure
Actually F4G is a programming environment similar to panatools, not a machine, it stands for "Fuji 4th Generation". The connection being questioned is to the communication network, and yes with the proper hardware you should be able to connect more t
Electronics Forum | Tue Nov 29 08:32:08 EST 2005 | stefwitt
Particular as a small company and limited resources you�ll be requiring a lot of assistance from the machine vendor. Did you check which other machines are used in your area and if there is already a local service tech? Did you get in contact with o
Electronics Forum | Sat Feb 16 16:14:20 EST 2013 | ericrr
Have you done a post-mortem on the blown fuse? Assuming it is a glass fuse, if it is all black around the glass then replacing the fuse will be pointless. (the new fuse will just blow again, making a black mark or BLACKER mark all around the glass)
Electronics Forum | Fri Aug 10 13:52:58 EDT 2001 | davef
When you say that glue viscosity changes for lot to lot, is this LOT TO LOT of your product OR Loctite�s product? And when you say that glue viscosity changes, what do you mean [eg, increase by � , decrease by � , er watt?]. What specifically is th
Electronics Forum | Thu Jun 10 21:43:18 EDT 1999 | Dean
| | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like poin
