Electronics Forum | Wed May 16 18:09:09 EDT 2018 | dleeper
Does the table move under the stencil than just sit there doing nothing? there is an optical sensor in the machine near the end of travel, sometimes solder past or dirt gets into it preventing the contact from being made. Another issue I vaguely rec
Electronics Forum | Wed Jan 18 12:57:22 EST 2006 | cyber_wolf
Since I have posted on this last, we have found that 99% of our nozzle sticking problems are do to part height problems. I have been told that CP6 machines are very sensitive to part height do to the amount of spring travel in the nozzle. If you hav
| 1 |
.gif)
.gif)
