Electronics Forum | Thu Aug 04 14:01:56 EDT 2022 | ttheis
We are having an issue with a Jade S200 we recently purchased. When opening the pillarcom software it is unable to establish communication with the machine. The power supplies and fuses all seem to be ok and at proper voltages. Checked as many connec
Electronics Forum | Mon Oct 17 13:58:09 EDT 2022 | cyber_wolf
I would say not very reliable. The component separator spring, pick point adjustment, and magazine have to be perfect. Your nozzles have to be perfect etc..etc... My general advice is move to a different platform if possible. I have worked extensive
Electronics Forum | Thu Oct 20 16:11:08 EDT 2022 | cyber_wolf
I have no experience with the MY100. Personally, I'm not a fan of platforms where the PCB is not stationary. Mechanical feeders typically require more maintenance than electronic. Yamaha is one of the few I haven't worked with. It is my understan
Electronics Forum | Wed Nov 16 17:18:42 EST 2022 | emeto
Volumes are not the only factor here. You might have low mix and low volume, but high complexity. Machine you pick based on the most challenging components you have to print/place/reflow. If boards are simple, than your level of expertise is importan
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
Electronics Forum | Sat Mar 04 05:55:40 EST 2023 | jrogalski88
So we have 3 new ITW/EAE Centurion ovens that all have issues when running nitrogen to keep the o2 ppm below 1000. It is always much higher, sometimes gets lower when no boards are loading in. They've had us replace valves and do an upgrade kit that
Electronics Forum | Thu Apr 20 22:08:07 EDT 2023 | saucyshawn
Mycronic is very expensive. But it does have a lot of good options and feeder count. JUKI I have always found to be limited to number of feeders and flexibility of individual machines. If you are upgrading from MannCorp there may be better options
Electronics Forum | Tue Jun 06 15:35:34 EDT 2023 | spoiltforchoice
> Spoil do you have any complaints about the > 710? Or is only Magyar that currently has a 710? > I might have conflated two comments. No I don't have a 710 (still on Semi auto :( ) , don't think anyone in the thread has said anything b
Electronics Forum | Wed Jan 17 08:41:07 EST 2024 | spoiltforchoice
The neat and simple solution is indeed a laser. However I have seen other quirky ways to denote a build revision. These include a resistor with a value marking that matches the build revision e.g a 1K marked 102 could indicate assembly 1.02. Another
Electronics Forum | Sun Mar 10 05:28:03 EDT 2024 | dimamalin
Hello friends, over three thousand specialists have seen my post, but only three have reacted, and I'm very grateful to them. Even the simplest remark would satisfy me, like "we have such-and-such stencil washing machine, we've been using it
