Electronics Forum | Tue Dec 19 10:08:10 EST 2006 | George
Grant, Why don't you try a water-base flux which is No-clean, VOC-free also? I have tried the 270WR flux from AIM with good results even on lead-free process. My $0.02, George
Electronics Forum | Sat Dec 16 18:27:52 EST 2006 | bvdb
We've been using the MCS-16F computer with a Fuji IP-1 for about 9 months and wonder what the "Hard Disk Maintenance" feature does. We have no documentation on this feature. Best Regards, Bert
Electronics Forum | Tue Dec 19 03:40:38 EST 2006 | aj
I had this happening before. It is a simple adjustment on the Z-axis belt. Basically the dog is not making the sensor correctly and driving on further. I think you have a lot more issues if the shaft was damaged. aj...
Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf
We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr
Electronics Forum | Wed Dec 20 17:00:29 EST 2006 | aj
Have you contactd your Fuji Engineer for advise. I would really look at the z-axis belt setup before investing that sort of money. We had the exact problem here and that is all it was. aj...
Electronics Forum | Mon Dec 18 12:22:21 EST 2006 | russ
Sometimes I would have to agree!! Wonder how they clean it all up? and how long does that robot last anyway? hahaha Russ
Electronics Forum | Tue Dec 19 03:32:11 EST 2006 | ungun
Is there any method or machine that i can use to check glue size. I need to check 90% of the bottom side pcb area that have 200 glue point within 15 to 30 sec.
Electronics Forum | Tue Dec 19 07:16:56 EST 2006 | Nuno
There is many Bond dispenser that have the Option to check the area & adjust in case of NG area . You just make the value of area & interval for check and correct . The Ones that I know is Panasonic HDF (great Output 0.07 tact time ) And Fuji GL5 ser
Electronics Forum | Tue Dec 19 04:04:52 EST 2006 | ec
Hi, I been facing this problem in the past...... Now, I have change to printing. In the past, glue dotting is my bottom neck and need to use 2 glue dotting machine....and now, with printing proces, no more bottom neck in glue process and quality als
Electronics Forum | Tue Dec 19 15:36:12 EST 2006 | zanolli
Does anyone have any reliability history on using compression mount connectors, such as LGA sockets (no soldering of contacts as contact exerts spring pressure on PCB pad) to PCB�s with immersion Au or ENIG finished pads?