Electronics Forum | Fri Nov 07 06:45:13 EST 2014 | cot628
Has anybody had issues with the Mydata centering jaws causing esd and part damage. I understand we can lower the force on the components but ESD is my main concern. In the past I heard of companies testing the centering jaws because of this concern.
Electronics Forum | Thu Nov 13 13:12:57 EST 2014 | jimmyboz
Are you using MCS1 or MCS2 software on the MCS16? For MCS1 I would have to try and remember, haven't seen that software in 20 years. For MCS2 in the PD make sure nozzle size, nozzle size min, and nozzle size max are all set to Med.
Electronics Forum | Fri Nov 14 09:47:19 EST 2014 | jpal
Thanks for all the remarks. I am tending toward the move the pot method. I am concerned about parts tilting from square if moved or held at an angle. I won't need to deal with board pallets, board clamp mechanisms, etc. Plus I found the moving board
Electronics Forum | Thu Nov 13 14:29:17 EST 2014 | proy
I will soon be filling an electrovert solder module which is only going to be running one (lambda) nozzle/pump. this leaves quite a bit of solder volume I am going to have to put $$ into. Has anyone here used iron bars or spacers or bricks or other
Electronics Forum | Fri Oct 30 19:03:17 EDT 2015 | hawaii11
I would try FAB 3000 for Advanced DFM checks, I believe since your post, many updates and bug fixes have been completed. Or if you're not looking to spend so much $$, try DFM Now PRO. Here's a comparison grid showing you all the features. http
Electronics Forum | Tue Dec 02 06:07:00 EST 2014 | sarason
A trick I used to use doing RF design was to have on the edge of a panel, a stripline that I could hook up to a Network Analyser to check board impedance. You could do this to verify if the fault is in the no wash process or a board manufacture proce
Electronics Forum | Sun Oct 04 17:11:27 EDT 2015 | bernhard
As an employee, I was been working for a long time at the Royonic company as an engineer. During that time at Royonic, I did manage the development and the service (also training) for all the Royonic Assembly tables including the 500 systems machines
Electronics Forum | Wed Nov 26 13:20:47 EST 2014 | kkay
We have a lot of large through hole caps and we run everything through a wash process. Unfortunately water makes it's way inside the sleeves that the caps are shrink wrapped in. Has anyone found a way to prevent this from happening? We are running at
Electronics Forum | Thu Dec 11 02:24:37 EST 2014 | vladicac
We found out what was the problem. If you happen to get the same error be sure to check if you have access to all COM ports. Also check CMOS battery. Because of low battery voltage all BIOS settings were lost. Because of that we had to reconfigure ou
Electronics Forum | Mon Dec 15 18:22:36 EST 2014 | mcapizzi
As was stated, there are a number of variables that could come into play. I have used AirVac DRS26 and SRT Machines. We are now using Shuttle Star which has IR as well as hot air heat. This works much better for us. You can view these at. http://www.