Electronics Forum | Sat Oct 24 23:26:43 EDT 2015 | thefinder
Hi. Have a problem with a QSA 30 machine. show me a error at the end of set up program. CAN'T ANC OPEN and then show me on the next row message. invalid place position x. if anyone has any suggestions please tell me.
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Thu Nov 05 12:54:46 EST 2015 | emanuel
I found this supplier and several others from China. So far very bad experience, one sent a broken unit, another required bank transfer and only after it was received he claimed he tested the only unit in stock and found it was defective. I was very
Electronics Forum | Thu Dec 03 14:37:53 EST 2015 | proceng1
Are you running a water or alcohol based flux? We run a water based product and it stays in the tank with the stone all week and is emptied and cleaned at the end of the production week. Never once have I stored the stone in thinner and I've never
Electronics Forum | Thu Nov 12 10:16:25 EST 2015 | goodting
Good day. I am asking if anyone knows how to access/have a copy of our BIOS file. This BIOS file which was designed by Phoenix , called biosrec.zip. Each day, we used the main EPC-1316(PCA,CPU/PMC)card to boot our Advantis machine; but the speciali
Electronics Forum | Fri Nov 20 23:22:52 EST 2015 | rx8pilot
Hello, I am trying to figure out if it is possible to program the index distance on Quad Tyco Feeders. I recently got a Quad IV-C and on the 16mm feeders, they index 12mm where I have an 8mm pitch tape. It is a non-IQ machine so I am looking an man
Electronics Forum | Fri Dec 11 19:59:40 EST 2015 | dontfeedphils
What exactly are you looking to verify? Following the manufactures recommended schedule for calibration should be enough. Another option is many AOIs have an option to run a bare board, when doing this it will invert what it's looking for, so every
Electronics Forum | Tue Dec 15 02:00:32 EST 2015 | padawanlinuxero
We do what here is call a master, this board has a bunch of misalign components, missing components, bad solder joints, crack components, and other defects that we want the AOI to look for, now we compare what the AOI finds with a list of the defects
Electronics Forum | Mon Nov 30 17:41:54 EST 2015 | palsingh
Shonen, We manufacture PCB's at Macrotron, Inc in Fremont, California. Feel free to call us at 510-683-9600 to discuss cost and options. We are very affordable and test each device to ensure consistent quality. Kim Macrotron Systems 44235 Nobe
Electronics Forum | Mon Jan 04 23:02:20 EST 2016 | a290668789
It depends on the board complexity and the volume you needed. For standard PCB in prototype and small volume, suggest you http://www.pcbgogo.com/b. For complex board (e.g. HDI board), suggest you fastprint and Yuwei. All of them are in China. Hope i
