Electronics Forum | Wed Oct 21 06:16:49 EDT 2015 | eniac
Dear DeanM, I have the same thoughts about quantity of solder paste. Also I think about poor wetability of some pads (walls) on modems. I'm glad that my ideas are the same like yours and other members of forum. I will try to increase pads dimensions.
Electronics Forum | Mon Oct 12 19:12:13 EDT 2015 | cusackmusic
Looking are "new" stencil printers. Have heard a lot of people like the Ekra. I see there are X5s, X4s, and X1s available all over the place. I can't figure out what the differences are. They seem similar, and are similar vintage. Any insight?
Electronics Forum | Wed Oct 14 14:54:00 EDT 2015 | cbeneat
We currently have five X5's. Which we like. My only other experience with other EKRA models was, we had an X3 loaner a few years ago, and after a week of trying to use it we wanted to take a sledge to it...so in a nutshell, X5-great, X3-not so much
Electronics Forum | Thu Oct 15 14:58:18 EDT 2015 | charliedci
In my experience over last 10 years with (Juki, Heller, DEK, Ace, Speedline, Mirtec) they all have good support and are responsive to our needs, whether it is phone/online support or in scheduling a visit. The real differences are with the knowledge
Electronics Forum | Mon Oct 19 10:23:24 EDT 2015 | atekcare
Great message that all should pay attention to, I know we do here and have for many, many years knew that good communication and expectation setting was the foundation of satisfied customers. I'd like to hear more about your independent services bus
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Thu Oct 22 03:10:49 EDT 2015 | myleb
I already check that sir, maybe its a loose > connection or board problem. maybe the ssr board was damaged. try swap the ssr between the A and B stage. Open the machine cover at AF/BF stage, it's the down left board with many connectors (have COV1
Electronics Forum | Sat Oct 24 23:26:43 EDT 2015 | thefinder
Hi. Have a problem with a QSA 30 machine. show me a error at the end of set up program. CAN'T ANC OPEN and then show me on the next row message. invalid place position x. if anyone has any suggestions please tell me.
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Thu Nov 05 12:54:46 EST 2015 | emanuel
I found this supplier and several others from China. So far very bad experience, one sent a broken unit, another required bank transfer and only after it was received he claimed he tested the only unit in stock and found it was defective. I was very
.gif)
.gif)
.png)