Electronics Forum | Thu Oct 15 14:58:18 EDT 2015 | charliedci
In my experience over last 10 years with (Juki, Heller, DEK, Ace, Speedline, Mirtec) they all have good support and are responsive to our needs, whether it is phone/online support or in scheduling a visit. The real differences are with the knowledge
Electronics Forum | Mon Oct 19 10:23:24 EDT 2015 | atekcare
Great message that all should pay attention to, I know we do here and have for many, many years knew that good communication and expectation setting was the foundation of satisfied customers. I'd like to hear more about your independent services bus
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Thu Oct 22 03:10:49 EDT 2015 | myleb
I already check that sir, maybe its a loose > connection or board problem. maybe the ssr board was damaged. try swap the ssr between the A and B stage. Open the machine cover at AF/BF stage, it's the down left board with many connectors (have COV1
Electronics Forum | Sat Oct 24 23:26:43 EDT 2015 | thefinder
Hi. Have a problem with a QSA 30 machine. show me a error at the end of set up program. CAN'T ANC OPEN and then show me on the next row message. invalid place position x. if anyone has any suggestions please tell me.
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Thu Nov 05 12:54:46 EST 2015 | emanuel
I found this supplier and several others from China. So far very bad experience, one sent a broken unit, another required bank transfer and only after it was received he claimed he tested the only unit in stock and found it was defective. I was very
Electronics Forum | Thu Dec 03 14:37:53 EST 2015 | proceng1
Are you running a water or alcohol based flux? We run a water based product and it stays in the tank with the stone all week and is emptied and cleaned at the end of the production week. Never once have I stored the stone in thinner and I've never
Electronics Forum | Thu Nov 12 10:16:25 EST 2015 | goodting
Good day. I am asking if anyone knows how to access/have a copy of our BIOS file. This BIOS file which was designed by Phoenix , called biosrec.zip. Each day, we used the main EPC-1316(PCA,CPU/PMC)card to boot our Advantis machine; but the speciali
Electronics Forum | Fri Nov 20 23:22:52 EST 2015 | rx8pilot
Hello, I am trying to figure out if it is possible to program the index distance on Quad Tyco Feeders. I recently got a Quad IV-C and on the 16mm feeders, they index 12mm where I have an 8mm pitch tape. It is a non-IQ machine so I am looking an man
