Electronics Forum | Tue Feb 22 22:39:22 EST 2022 | cirsol
Hi, Sorry I didn't see your previous post. I do have an update but will answer your questions first. {So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ?} Yes that's correct, we only rebuilt the MC HDD but were not able t
Electronics Forum | Wed Jun 04 10:49:23 EDT 2008 | arbarr
The the HDD onwindows 2000 pc running Fuji Flexa for 5 m/c's on our smt assembly line died 2 weeks ago. We've since reinstalled a new HDD. To cut along story short Fuji via their agent here (Productivity Partners Formerly Astro) after 14 days do
Electronics Forum | Thu Jun 05 17:54:42 EDT 2008 | iantech
The the HDD onwindows 2000 pc running Fuji Flexa > for 5 m/c's on our smt assembly line died 2 weeks > ago. We've since reinstalled a new HDD. To cut > along story short Fuji via their agent here > (Productivity Partners Formerly Astro) after
Electronics Forum | Thu Jun 29 03:04:19 EDT 2023 | ttheis
The first thing we do with all machines we buy is back them up. First we backup the calibration info, then we remove the hard drive and image it to our server. If the hdd dies, we can restore it to a new one. Look on eBay for new-old stock on the har
Electronics Forum | Mon May 24 05:56:59 EDT 2021 | bukas
hello James, you should be getting error message " no pneumatic pressure " when trying to get machine into READY state with no air supply. maybe you should check HDD health. while you are there, make HDD backup; and if machine uses ATA driv
Electronics Forum | Mon Feb 01 21:39:51 EST 2021 | dekhead
Most probable is encoder feedback failure... check encoder connections.
Electronics Forum | Tue Jul 02 07:11:31 EDT 2002 | davef
There is nothing inherently wrong with voids in solder connections. They: * Do indicate that the reflow soldering process is not well controlled. * Can comprise the strength of the solder connection. Look here: http://www.smtinfocus.com/smt_failure
Electronics Forum | Fri Jun 03 14:21:48 EDT 2011 | rgduval
I haven't seen that particular fail....but... What was the failure with the M controller? Might try moving your MOT cards around, to see if the failure follows one particular card. If so, you'll know you need a new MOT card. That might satisfy th
Electronics Forum | Fri Oct 28 17:50:17 EDT 2016 | ttheis
Found a broken wire in the data line and I thought that was it for sure but was not. Checked continuity of the data cable and it is ok now but still no comm. The embedded controller status window shows "send failures" but no "reply failures." Winco
Electronics Forum | Thu Dec 24 14:37:58 EST 2020 | marcelorotofrance
Hi again Bob. I have checked the machine and it resulted that the files of that program were corrupted in some way. All other programs worked fine. I have a back up copy of all progs in a different drive so I fixed it. Two days ago there was a huge b