Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Mon Feb 07 08:26:38 EST 2022 | micropak
So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ? The Installer Floppy disks for MC software will install a default IP address and the Node Name. You have to change not only the IP addresses (in HOSTS file) but also the
Electronics Forum | Wed Jun 21 20:41:26 EDT 2000 | Dave F
Gary: Regular FR-4 will HASS. HASS has largely fallen from favor, because: * Process is difficult to control, so not to strip the life from components * Failures under HASS have nothing to do in use failures. If you insist on continuing with this,
Electronics Forum | Wed Jun 08 23:04:26 EDT 2022 | SMTA-64387544
Au thickness of 0.125 um should not cause solder joint embrittlement. Also, PCB fab should offer Au thickness range between 0.05-0.075 um for better process control and reliability. Higher Au thickness may suggest black pads leading to solder joints
Electronics Forum | Thu Dec 09 04:11:54 EST 2021 | cirsol
Hello Forumers, I'm hoping there might be a SiPlace expert or two trawling the forum. We have an S25 machine that essentially has a failed MC harddrive and we're trying to rebuild a new one. Attached are a few images and perhaps something shown her
Electronics Forum | Wed Aug 01 11:22:25 EDT 2012 | davemac62
ERROR: "The specified i/o operation on DeviceHarddisk0Partition01 was not completed before the timeout period expired" This is followed by out of control conveyor speed and zone temps. Oven recovers when the error is acknowledged. This is happenin
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
Electronics Forum | Mon Dec 26 12:21:15 EST 2005 | davef
Sure, you can use X7R dielectric ceramic capacitors on mixed technology boards. You need to be aware of the limitations and design and control your process appropriately. Continuing: * BIG cracks show as hard failures * Small cracks show as a leakag
Electronics Forum | Fri Jan 19 07:21:07 EST 2007 | meritajs
Thank all for your advices. But we had sistem error,which was connected,how we could undestand with failure main PC controller boards.We had swoped winchester memory block and Zevatech operation was restored Best regards Peter