Electronics Forum | Thu Sep 13 17:29:02 EDT 2007 | fnorradd
I am currently having a problem with uncut legs on one side of axial components from a universal dual head insertion machine. Initially it was thought that the anvil on one side was engaging slow so I stripped down and changed the seals in the botto
Electronics Forum | Tue Sep 18 08:14:31 EDT 2007 | jeffharley
This would not produce the condition that Darron is seeking help for as the vcd would stop due to not seeing a clinch in signal with a mechanical jam.
Electronics Forum | Tue Sep 18 16:30:29 EDT 2007 | slthomas
I think Darron drove that DHVCD off'n a tall cliff. There's a whole bunch of stuff that could cause no-cuts, but without more information (dings on leads, full insertion, dry-run performance, continuity checking results) we'd all be (and have been)
Electronics Forum | Fri Sep 14 10:42:03 EDT 2007 | slthomas
Are you sure the anvil is coming up? You might try running a program w/o parts or boards (no continuity check) and watching to see if everything is moving when it should be. Do you use continuity checking? If so, what are the results?
Electronics Forum | Mon Sep 17 21:20:53 EDT 2007 | molos21
You should check your back stroke of the cutter. The backstroke is probably too long which cause a mechanical jam when you fire the cut and clinch. The anvil goes up first and then come the cut and clinch at this point the jam should appear. There is
Electronics Forum | Thu Oct 27 01:43:41 EDT 2005 | adlsmt
Do you have any advice on preventive maintanance? Universal does not call for much. We have the machine running now. It is incredible for a $150K machine. We have had no maint issues but I want to make sure it stays running the way it is. I have visi
Electronics Forum | Wed Jan 23 11:14:11 EST 2019 | assuredtech
Do you have a spare head? or have you tried swapping the head to a different module? Is it always the same component (element)? Inspect the component under a scope / perhaps a packaging / adhesive issue. If the component is staying on the nozzle what
Electronics Forum | Wed Jun 15 22:27:40 EDT 2011 | pkamath2
Hello, My company recently installed a Positive Displacement Pump on a GSM Pick @ Place machine for dispensing chipbonder (loctite 3621) dots before mounting chip components. The head uses Universal stand nozzles (single port-small dot, dual port 0
Electronics Forum | Wed Jan 23 18:57:09 EST 2019 | nikevoo1
Is it possible to have too much grease on mechanical valves and because of that something has been clogged? Or mechanical valve O-rings to be a problem? https://imgur.com/a/ZHShMAH https://imgur.com/a/SzAWIL0
Electronics Forum | Thu Oct 22 14:44:18 EDT 2020 | greasemonkey
I have recently taken charge of a hesse bondjet BJ820, I have zero experience of bonding before this and to be honest, Im finding it troublesome to say the least!! basically wire keeps snapping. I would like to set the head up from scratch but the ma
