Electronics Forum | Sat Sep 26 14:54:52 EDT 2015 | ercdave1
Hello, just a quick update on this issue. I disabled head 2 on beam 2 which was the second head I worked on, and left only active the head that I had work with first and ran dry cycle with. after disabling the head 2, the machine zeroed with no pr
Electronics Forum | Wed May 21 09:03:52 EDT 2008 | bing007
I have been confronted with a MPM with a rheometric pump head on and have not had much to do with these. It is giving varying results on the down line paste AOI and is not responding very much to changes in pressure, speed etc. It is a 16inch pump, w
Electronics Forum | Tue Oct 21 14:53:44 EDT 2008 | daxman
Hey, Are you having a problem with only 1 component from head 1 or all components on head 1? Thanks, Dax
Electronics Forum | Wed Sep 30 13:09:12 EDT 2015 | ercdave1
Hello Rob, I was able to get the machine to zero, apparently replacing the circuit board on head 2 conflicted with head one even matching the jumper settings to the old board. Once I marked the head as not mounted, head 1 zeroed. I re-checked the ju
Electronics Forum | Mon Feb 11 13:00:00 EST 2002 | Roy Barton
I am looking for some equipment with a fairly undemanding capability. I would appreciate pointers to potential suppliers. Dispense size 0603 chips only, speed can be as low as 60 chips per minute. Only one type of component (ie one reel) is loaded.
Electronics Forum | Wed May 21 13:38:22 EDT 2008 | pjc
Solderpaste types have a big effect on print performance. Go to this link to see if the solderpaste you are using has been tested, see "Rheometric Pump Paste Tests" under MPM: http://www.speedlinetech.com/news_publications/application-notes.aspx?OnI
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Mon Feb 11 22:05:44 EST 2002 | davef
You may not find a supplier with an "out of box" solution. But you might be able to jury-rig something without too much pain and cost. Try this: * Buy a fairly brainless feeder [like an old quad feeder] from an used equipment supplier / broker [sea
winsouce.jpg)
.gif)
