Electronics Forum | Mon Aug 31 19:15:36 EDT 2020 | dilogic
We have GSM2 with FlexJet heads (an older one). There are 7 sensor amplifiers (with LED indicators) for touchdown detection and one for z-safe detection which is of a different type (with numeric LED indicator). I can't find anywhere what the right n
Electronics Forum | Sat Feb 25 12:01:28 EST 2017 | ttheis
I'm setting up a asymtek millenium m-cob style dispenser for the first time and running through the master offsets routine but when it attempts to find the needle in the nsz needle sensor it works in the x direction but when it attempts to locate in
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Thu Mar 20 15:57:57 EDT 2014 | edwaterfall01
The numeric display number should be higher but only when all 7 spindles are moved down slightly from the full up position. The 7 spindles retract up to the Stop Bar. Each spindle assembly has a tapered hole thru it. This hole is in the block with t
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Thu Aug 18 12:46:43 EDT 2011 | jdengler
In the center of the head shaft there is a rod that is used to flag 2 sensors at the top of the shaft. This lets the machine know when a nozzle is attached. Check that the sensors are working correctly and the rod moves freely. The sensors are fib
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Tue Sep 18 15:15:10 EDT 2007 | jdengler
Jeff, You assume too much. Not all VCD's had clinch in sensors. Darron did not tell us what vintage this machine is so what habsfan said could be the problem. We need more information to help. Does the machine stop when it doesn't cut the lead? D
Electronics Forum | Tue Mar 07 21:57:54 EST 2017 | ttheis
It was indeed the fact that the height sensor needle was moved away from the dispense needle. Happened to find a height probe rod with longer reach in the spare parts shipped with the machine; with the height sense probe next to the needle the machin
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
winsouce.jpg)
