Electronics Forum | Mon Oct 28 15:13:44 EDT 2013 | larrygroves
It will require an alignment. The tools are usually included in the toolbox, one L shaped magnetic tool, a small square glass plate and there is a tool in the nozzle changer. You can buy them seperately if you dont have them. There is a bigger qu
Electronics Forum | Wed Aug 17 11:16:33 EDT 2022 | thegreatresisthor
Hello everybody, has anyone else encountered the malfunction of the head crashing against the right inner board side of it´s cabin after hitting the stop button whilst an fiducial error happens? as far as i know from my collegues its not always in th
Electronics Forum | Wed May 22 09:47:29 EDT 2002 | ghenning
Has anyone out there installed these devices on an S20 or had a head crash without them? Are they worth the investment to safeguard the machine? Is there another solution that one might consider?
Electronics Forum | Wed Nov 21 13:42:12 EST 2007 | etienne
To answer your question: During my experience with Topaz machines, we had to replace 4 Heads on different occassions with different operators involved. Also I encountered several Head crashes with Eclipse machines. To buy such replacements here in Ma
Electronics Forum | Thu Jan 23 14:52:05 EST 2020 | jesusc
Hello, Does anyone knows how to perform AMF correction procedure? I need help in calibrating placement offsets. Recently we had an event where head 1 crashed a feeder and damaged it. We have already replaced the nozzle assembly and used a jig to ma
Electronics Forum | Tue Jun 04 15:21:20 EDT 2002 | jax
To make it simple: A Feeder protection plate is just a flat piece of metal that hangs over the feeders, inside the machine, and keeps the feeder cover from popping up and crashing the head.
Electronics Forum | Thu Sep 27 16:21:03 EDT 2007 | adlsmt
We have two, about 2.5 years old and 1.5 years old. We run all kinds of parts and get about 18K to 20K CPH. The pick accuracy is fantastic so have saved a lot of $$$$ by not having dump buckets full of parts at the end of runs. I could not be happier
Electronics Forum | Mon Jan 29 15:21:56 EST 2007 | flipit
If you teach your feeders, you can no longer gang pick correct? I have never had a dual beam or dual head GSM before. However, if you teach feeders with the fiducial camera and your picks are still off, there is an offset in one or several spindles
Electronics Forum | Wed May 25 23:45:04 EDT 2022 | SMTA-64387687
1. The jetting head flies very low to the level of the board. So, performing AOI function will crash the head. 2. AOI is performed close to the end of the line, after P&P or reflow. Are you planning to run the boards back-and-forth, on the line? 3. L
Electronics Forum | Mon Nov 30 10:04:26 EST 1998 | Clint Hardee
Yes, the GEM series feeders are quite different. In fact, if you put CSM feeders on a GEM machine, you will probably break nozzles and crash the head due to the fact that the CSM feeders have a mechanical arm that sticks up toward the front of the bo
