Electronics Forum | Mon Oct 21 19:42:08 EDT 2024 | tomazicrok3
Hi, I have Samsung CP40CV pick and place machine. And i want to know if i can somehow disable head 3 because i get cant restart motor alarm and some z axis error. Greetings
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Thu Jun 08 22:54:57 EDT 2017 | palsrvs
Hoping to get help on our Samsung CP40. We are trying figure out what part to replace for a Z height motor alarm detected Error Code 1523. Originally Head 1 was having this error. Swapped out I/O board and Z-Axis control for head one and same error s
Electronics Forum | Mon Jun 12 11:14:10 EDT 2017 | bobpan
Sounds to me like the z-encoder could be a problem. I cant remember but you may be able to disable a head in the system settings. Bob
Electronics Forum | Fri Jun 09 07:32:13 EDT 2017 | bukas
it sounds to me like a home sensor. try adjusting sensitivity if possible. move head manually to determine position at which home sensor is activated
Electronics Forum | Wed Jun 21 21:28:34 EDT 2017 | maddy
Hi We had same issue with Head 2.if you find solution let me know as well. thanks
Electronics Forum | Wed Jan 23 07:42:34 EST 2019 | rolfi
Hi, we had the same issue with our CP30V and head1. Did you solve the problem? Please let me know as well. Thank you.
Electronics Forum | Mon Jun 12 21:16:41 EDT 2017 | kahrpr
you can not just take the motor off and change it. the motors have a home pulse singnial. the motor has to be in a certian position the home pulse position when the flag hits the sensor. When you remove the motor you have to mark the motor gear when
winsouce.jpg)