Electronics Forum | Thu Jan 11 19:52:55 EST 2024 | travishemen
Check the top of the placing head. There are 3 screws around a piece that pops up when you push up on the nozzle. I had one once that was vibrating and causing the part to place slightly off angle. It is exposed to the vacuum used to pick the part
Electronics Forum | Thu Jan 11 19:18:24 EST 2024 | madisreivik
Hello ! FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect. It happens randomly, maybe 1 part from 30. It
Electronics Forum | Thu Jun 07 18:59:41 EDT 2018 | smonk
Hello, I have a Juki KE 740 pick and place machine which i purchased used about 1 year ago. I am trying to run the self calibration feature which measures the offset of the placement heads to the camera on the group head. According to the manual som
Electronics Forum | Tue Mar 13 19:27:33 EDT 2018 | maustin
I have an old Zevatech 740 machine that, until recently, was running well. In the last few weeks, the RH head has started giving me issues. When it picks up a component (and early on in most of my programs it will be picking up chip resistors or ca
Electronics Forum | Thu Mar 15 18:18:36 EDT 2018 | maustin
Yep, checked the nozzle (that was my first port of call). Had a look at it under our microscope, and also swapped it out for another nozzle to be sure. The problem still exists. You can set the theta speed, but only to Fast, Medium or Slow. I've
Electronics Forum | Thu Mar 15 17:50:18 EDT 2018 | sarason
Possibly a loose grub screw on one of the shafts controlling rotation or the sensor ot gray code wheel on the rotation servo motor. or even a small fault in the program eprom, Good luck sarason
Electronics Forum | Tue Mar 20 22:53:16 EDT 2018 | maustin
OK, with my masterful powers of deduction, I have been able to resolve the problem. Upon further investigation, it became apparent that the issue was restricted to those components that had the laser alignment level in the component data set to -0.2
Electronics Forum | Thu Mar 15 01:43:52 EDT 2018 | reckless
Unfortunately, I can't give any help but wanted to ask about your experience with the 740 machine? How reliable has it been for you? Would you buy another or upgrade to newer machine? I just bought 2 pm570s arriving tomorrow. If they work out wel
Electronics Forum | Thu Mar 15 12:36:04 EDT 2018 | deanm
Is the nozzle in good condition? If it is not flat because of damage or wear, it might loose vacuum and the part may have a tendency to shift. I don't have experience with these machines but how do you know the spindle is spinning slower when the co
Electronics Forum | Thu Mar 15 18:21:26 EDT 2018 | maustin
Cheers. I have a suspicion its an error with whatever part of the machine measures shaft rotation, but the grub screw thing is an easy one to check and eliminate. I'm only guessing from what I can see, but it looks like its setting the component at
