Electronics Forum | Thu Mar 20 15:57:57 EDT 2014 | edwaterfall01
The numeric display number should be higher but only when all 7 spindles are moved down slightly from the full up position. The 7 spindles retract up to the Stop Bar. Each spindle assembly has a tapered hole thru it. This hole is in the block with t
Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Sat Feb 25 12:01:28 EST 2017 | ttheis
I'm setting up a asymtek millenium m-cob style dispenser for the first time and running through the master offsets routine but when it attempts to find the needle in the nsz needle sensor it works in the x direction but when it attempts to locate in
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Wed Jun 11 08:53:53 EDT 2014 | fredcalkins
That would be easy to check. Degaus the whole nozzle not just the tip. It should take more than a week to become magnetized again. If it becomes magnetic sooner maybe degauss the head? I would also make sure your vacuum does not come on till the noz
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Thu Sep 13 17:29:02 EDT 2007 | fnorradd
I am currently having a problem with uncut legs on one side of axial components from a universal dual head insertion machine. Initially it was thought that the anvil on one side was engaging slow so I stripped down and changed the seals in the botto
Electronics Forum | Mon Aug 01 18:33:21 EDT 2005 | crishan
Hi All, We are not using a Vib. bowl feeder, or stick feeder, these parts are on a reel. The pick & place machine we are using is a Panasonic brand YV100X, its a single head with 8 nozzles. What we are finding is that the component package size is
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
