Electronics Forum | Thu Jul 28 18:12:47 EDT 2011 | asksmt
Hi, what kind of issues i could get if the i do not provide heal properly in my footprint ? In my current design 0603 resistor package footprint heal is missing by 3 mils each side Please help
Electronics Forum | Fri Dec 16 09:02:55 EST 2005 | Burgandy
I think the whole point with smocks Peter is that they are ANTI static......and they must be used in conjunction with heal straps.....but IMO......heal straps or ESD shoes are all you need. Now, I would recommend finger cotts to keep contamination o
Electronics Forum | Thu Dec 22 06:58:03 EST 2005 | pjc
They just make it look good, that's all. ESD flooring, heals straps and wrist bands have function, smocks do not.
Electronics Forum | Thu Mar 23 12:21:11 EST 2006 | Rob
Well, at least it gives you an option if you ever have a heavy fall & land on your head. Could you not modify an ESD coat & add some copper welding rod to give it that flying in the wind look? You could even decorate it with some disposable heal st
Electronics Forum | Tue Oct 24 14:58:08 EDT 2006 | ehess
the guy has a borken collarbone, and this "promotes healing by inducing a weak electrical current at the fracture site." The distributor says it's ok. I kind of wonder if it really is.
Electronics Forum | Tue Oct 24 16:30:18 EDT 2006 | jax
Without getting into an electrical field promoting bone growth... As long as he is grounded through heal straps and/or wrist straps, it should be fine. Although I imagine being grounded would neutralize the "Bone Grower"
Electronics Forum | Tue Mar 23 09:31:39 EDT 2010 | rmitchell
Hi, To provide closure and help the healing process and maybe benifit someone else down the road... The problem was the UPS battery had gone dead. Back side of oven, near the exit end. rob
Electronics Forum | Thu Jul 28 22:35:58 EDT 2011 | davef
The consequences of poor heel formation in solder connections include: * Lower solder joint strength * Possible intermittent short circuits * Reduced first-pass yields * Increased inspection cost * Increased rework cost * Likely field failures * Like
Electronics Forum | Thu Feb 24 20:13:22 EST 2022 | dwl
They don't look that bad, especially for SN100. There is evidence of wetting on the toe and the paste on the pad seems to have reflowed properly. What does the heal look like? That's the more critical part of the solder joint for Gull leaded parts.
Electronics Forum | Thu Aug 30 13:02:37 EDT 2012 | rway
This may have been asked, but what ESD protection does your facility already have? With proper techniques and equipment, this should be a non-issue. As long as folks aren't using the pcb's to comb through their hair, you don't have to worry about i
