Electronics Forum | Wed Mar 09 16:55:02 EST 2011 | davef
We agree with the previous poster. Open-up your aperture to increase the amount of solder paste. If you don't have a heel fillet, go home.
Electronics Forum | Tue Mar 08 02:28:03 EST 2011 | nagesh
I have an issue with PLCC Insufficient Heel solder joint fillet.The aperture dimension is : 30 x 100 mils on PCB & on stencil also(1:1 per gerber).Rohs Process. My stencil thickness is 5mils due to presence of Tssop & QFP package & i cannot increase
Electronics Forum | Thu Apr 12 20:44:58 EDT 2007 | raychamp007
If the solder joint meeting 8.2.5.4, minimum side joint length(D) and also meeting 8.2.5.6, minimum heel fillet height (F) but the heel fillet NOT extend to the mid point of outside bend. It is acceptable?
Electronics Forum | Thu Mar 22 17:31:08 EST 2001 | davef
Hold off on the sharp knife for little bit. [Yano, I get "queasy" when I see much of my blood, but other people�s blood doesn�t bother me much. Weird, eh?] [Oh bye-da-bye, I didn�t win the bar bet on "Ground Hog Day". I didn�t loose it either. T
Electronics Forum | Mon Mar 26 11:20:39 EST 2001 | dblsixes
The pads are 0.070 x 0.012 ... as spec'ed, and as measured. The pad extends approximately 0.017 behind where the Class 3 fillet is required to be. (It used to be 0.037 on an older design that exhibited similar, but not as bad of heel fillets.)
Electronics Forum | Thu Mar 22 21:53:49 EST 2001 | davef
Don't mess with the doggie stuff until you get longer pads [and then you won't have to mess with it] because you'll just ruin your lead definition with more paste and still not have the heel fillet you desire.
Electronics Forum | Thu Mar 22 21:59:55 EST 2001 | dblsixes
ah ... but we had insufficient heel fillets in the old design toom when we had more pad area ... just not as bad
Electronics Forum | Wed Mar 03 06:13:23 EST 2010 | grahamcooper22
The picture shows that the heel of the device lead is not on the pad. Either bad placement or wrong pad dimensions. I imagine most customers would reject this joint as only a small part of the lead is actually in the solder. With no heel fillet the j
Electronics Forum | Thu Apr 12 20:32:31 EDT 2007 | davef
On one hand, nothing in 8.2.5.4 that states that you need a heel fillet. It only talks to the length of the side fillet. On the other hand, we suggest that you should use 8.2.5.6 to determine if your heel fillet is acceptable, after you have determ
Electronics Forum | Thu Nov 07 12:35:38 EST 2002 | slthomas
Sounds like you're talking about the "heel" of the lead not being soldered, in other words, no heel fillet, which IS necessary. That problem, for us, was attributed primarily to poor layout (insufficient length of pad extension to provide room for
.gif)
