Electronics Forum | Tue Mar 13 12:54:58 EDT 2007 | hynergy
You required the process control equipments. 1) Paste Height Checker: To measure the solder paste thickness after printing. 2) Temperature Profiler: To measure the reflow oven temperature whether is within the control spec.
Electronics Forum | Thu Mar 29 20:39:37 EST 2001 | peterson
AOI systems are a LONG way from being practical. You might impress potential customers (if you are a contract manufacturer) But they are basically an over-priced gimmick. Get your processes in line, buy a good 3D paste height checker, verify componen
Electronics Forum | Mon Apr 11 08:47:34 EDT 2005 | Rob
There's not many ways of doing it on the cheap except... Buy a second hand universal GSM1 with VME 630 vision, 0.5 mil per pixel camera & some expensive ceramic nozzles for the 0201's. This will be quite slow & the software quite awkward but lookin
Electronics Forum | Thu Apr 28 17:02:07 EDT 2011 | grasso1976
Has anyone had success utilizing the lifted lead/ height checker feature on a Mirtec MV-7L. We recently had two separate events where the machine did not detect a lifted lead using the ic/bridge inspector. The soldering results came back with out def
Electronics Forum | Wed Jun 26 13:15:18 EDT 2013 | hegemon
Thinking about it... If your sphere diameters were all the same, then your planarity should be established. Sounds like a job for an AOI type machine, with a laser height checker. I take it you have many of these to check, and are looking for someth
Electronics Forum | Fri Aug 07 14:52:43 EDT 2020 | glasscake
Does anyone have a comprehensive manual or some pages on how to setup/how the laser height functions work on a Mirtec MV-7U? (Mirtec Inspector 4.5.6) Even a sentence describing what each input for these tools do would be amazing. I FINALLY was able
Electronics Forum | Wed Oct 25 12:38:05 EDT 2000 | Phil
Hi there!! You know what your QA is doing is right, coz by measuring the solder paste height can avoid the following defects: 1.Insufficient solder 2.Short solder or bridging 3.Solder balls SPC monitoring for paste height checking is required
Electronics Forum | Wed Jul 11 14:45:22 EDT 2007 | samir
ECD, KIC, or any mfgr. of thermal profiling devices will charge a premium for "simple stuff". For example, ECD charges a grand for their "flux-o-meter", which is just a PCB with a hole pattern, a pallet, and pH-sensitive paper. You can easily ma
| 1 |
