Electronics Forum | Wed Jul 22 23:14:40 EDT 2020 | spoiltforchoice
Is that not an option you have to buy when you spec the Oven?
Electronics Forum | Fri Jul 24 13:55:53 EDT 2020 | cyber_wolf
Exactly.
Electronics Forum | Tue Jul 28 13:40:08 EDT 2020 | dwl
It won't hurt anything in the oven.
Electronics Forum | Wed Jul 22 22:19:07 EDT 2020 | kghadiya
Hello Experts, I am using Heller 1707EXL in my shop. From last 2 months I have faced component missing and flying problem. I tried everything to figure out the problem i.e. change solder paste, re-calibrate PnP machine, several oven recipe etc but s
Electronics Forum | Thu Jul 23 10:12:27 EDT 2020 | cyber_wolf
Blower speed control is an option. If you have it, there will be an icon on the toolbar. Hover the mouse over the buttons for description.
Electronics Forum | Thu Jul 23 06:15:33 EDT 2020 | bukas
There is a oven setup wizard on my 1809. your oven probably has one too. there you should be able to adjust blower speed for each zone.
Electronics Forum | Thu Jul 23 13:44:50 EDT 2020 | dwl
I used to have the same issue with reed switches on one product we ran. Same oven too. We ended up rigging up an "umbrella" with two titanium stiffeners and bare PCB as the roof. It was hokey but it worked.
Electronics Forum | Mon Jul 27 20:26:44 EDT 2020 | kghadiya
Good idea DWL, "Umbrella" thing works to solve this problem temporarily. But do you think it will cause any damage to hitter or heat zone?
Electronics Forum | Tue Aug 13 09:41:03 EDT 2013 | horchak
If it's forced air convection I'd check all the circulating fans and filters. Also if its a clam shell bonnet make sure it's closed all the way and the seal is good. You didn't specify whether it is one zone or the full length of the oven, I do not w
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
.gif)
winsouce.jpg)
