Electronics Forum | Tue Jan 11 13:29:45 EST 2022 | bmalhi
You can purchase full motor assemblies directly from Heller. Please contact service with oven serial numbers and motor location ServiceNJ@hellerindustries.com.
Electronics Forum | Wed Feb 02 19:55:31 EST 2022 | dwl
you may also want to try replacing the Motor capacitor. This is often the culprit on those blower motors. I found them on Amazon for $3. much better then $450 for a new motor.
Electronics Forum | Thu Dec 21 11:55:31 EST 2006 | realchunks
I have one form a year 2006. Uses the studds to keep track of revolutions. Four wires going to the motor.
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Mon Mar 20 10:25:30 EDT 2017 | cyber_wolf
@ Westshoredesign: Go take the top covers off your XPM's. Tell me if you see flux residue on the blower motors and the surrounding area. If you see this, grab ahold of the blower motor and rock it back and fourth. It is moves, the seals are melted o
Electronics Forum | Mon Sep 10 09:49:11 EDT 2012 | dyoungquist
We have a Heller 1707EXL that we purchased in 2006. During the first year we had 2 blower motors go bad. After the second one went bad, Heller sent a technician who replaced every blower motor on the oven at their expense. Since then it has been 5+
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Mon Apr 15 12:36:04 EDT 2019 | robl
We found the blowers were usually fine, but the capacitors strapped to the blower motors were failing. They were under $5 each from Digi/Mouser/Allied/RS. Worth keeping a few around. Last place had 12 Hellers including a 1500 doing ROHS with no is
Electronics Forum | Wed Jul 11 14:44:33 EDT 2007 | cyber_wolf
Ya I found that out while pulling the motor wires out of the terminal blocks.
Electronics Forum | Tue Jan 31 17:18:37 EST 2017 | mainenetservices
You can contact Heller service by email info@hellerindustries.com to get help with any issue. High Deviation or high process alarm could be due to one of the below reason. A. Blower motor in subject zone is not running – check for air flow B. Heat
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
