Electronics Forum | Sat Nov 04 11:57:20 EST 2006 | joseluis_amper
Hello, I have an oven with a big fail. The Control Unit. It is a 5 zones oven (BTU VIP70)and has more than 10 years, and I think that now is not interesting to repair. I think to buy an offer, an oven Heller of 7 zones + cool,(better for lead free).
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Mon Sep 10 09:49:11 EDT 2012 | dyoungquist
We have a Heller 1707EXL that we purchased in 2006. During the first year we had 2 blower motors go bad. After the second one went bad, Heller sent a technician who replaced every blower motor on the oven at their expense. Since then it has been 5+
Electronics Forum | Wed Jun 16 08:16:27 EDT 2021 | shmevan91
Hi, Could anyone shed some light why a mk5 13 zone heller ovens rail width won't auto adjust? has to be done by hand every time we change product. The board support rail will adjust just not the main rail, have tried swapping the two cards around bu
Electronics Forum | Fri May 15 15:09:03 EDT 2009 | pcbrookie
We recently added a 7-zone Heller, and have had a 5-zone Heller for quite some time. When the tech installed our new oven, we were told the new oven does NOT have the lifetime warranty on heaters and blowers. However, when we order parts for the ol
Electronics Forum | Wed Dec 14 07:09:15 EST 2022 | bukas
yeah that ok but, MARK5 or other MARK programs dont contain drivers for communication card, its called LANGO or something like that. if cleaning connectors and slots doesnt work try fresh install if you dont have HDD image. but first clean connectors
Electronics Forum | Fri Sep 07 09:13:21 EDT 2007 | smtirl
Folks, we've recently upgraded to Heller MKIII reflow ovens with Gen 9 cooling units. We're running N2 atmosphere at 1000ppm O2 and Kester256 solder paste. We're seeing a big problem with flux residues building up in the cooling section of the
Electronics Forum | Thu Apr 11 10:54:34 EDT 2019 | bmalhi
NITROGEN INLET: 2000 CFH ( 56.6 m 3/H R) MAX, 100 PSI (6.9 bar) MAX, 70 PSI (4.8 bar ) MIN For service inquires you can contact Heller by e-mail ServiceNJ@hellerindustries.com or call 973-377-6800 Ext. 5.
Electronics Forum | Thu Jun 17 18:01:07 EDT 2021 | bmalhi
Please check mechanical side if lead screws turning freely, binding screw could be the issue. Electrically please check if edge width motor is getting the required voltage. New ovens have the overload relay and the circuit protection fuse. Please con
Electronics Forum | Fri Jun 18 09:53:51 EDT 2021 | shmevan91
Hi, we have checked all of those and beenm in contact with heller but they said they will need to send an engineer out as they are also out of ideas, was hoping someone might've had the same issues as we have two ovens doing the same thing, wont move
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800