Electronics Forum | Mon May 02 15:36:40 EDT 2011 | marcpeo
One more note on this. The techs tell me that the main reason for the PV immediately matching the Set Point is that the software is in "Edit Mode". This is a mode that allows one to iterate the software without the oven running. That might also ex
Electronics Forum | Fri Jun 18 13:57:30 EDT 2004 | Claude_Couture
I remember writing a piece of software in quickbasic to compare two of those files and count how many common parts there were in the two files. The process was automatic, I could feed it a list of all the files I wanted to check and it would compare
Electronics Forum | Mon Jun 29 06:57:13 EDT 2015 | jlawson
Valor MSS has options for NPI Data preparation and processing, SMT programming, documentation, verification, materials management, traceability, and QA management not just in SMT but into backend process aka manual assembly as well as production plan
Electronics Forum | Wed Dec 02 12:02:33 EST 2020 | mikekeens
Depends on the programming that needs to be done - there is free software available such as GERBV - 'http://gerbv.geda-project.org/' but not that easy to use. For comparing BOM's there is some free software called MELD - http://meldmerge.org/ that's
Electronics Forum | Mon May 08 20:58:08 EDT 2000 | Dave F
Jay: Can't harly beat the price, eh? Every year or so "Printed Circuit Design" Magazine (www.pcdmag.com ???) bench mark board software. Their benchmarks are on their site. How about using them to evaluated your software? And comparing that ratin
Electronics Forum | Wed May 25 23:08:29 EDT 2005 | eb
Hello, I'm considering purchasing circuit cam at the facility I work at. I'm pretty familiar with circuit cam from a previous job and was wondering if anybody knows of any other similar types of software that can perform the same types of operations
Electronics Forum | Fri May 27 08:00:29 EDT 2005 | eb
Thanks for the responses. Like I said, I'm familiar with circuit cam and I already know what it can do. The problem is the pricing like some of the others have said. Have any of you used both circuit cam and any of the other softwares listed ( sony t
Electronics Forum | Thu May 26 06:23:46 EDT 2005 | CLampron
Good Morning EB, We too, are looking at a CAM system to accomodate these tasks. We have Unicam (Tecnomatix) 6.2 and are looking at Aegis (Circuit Cam), Valor, Sony TIMMS and Oracle. We have not made any conclusions as of yet. Unicam is strong as an
Electronics Forum | Fri May 27 11:12:04 EDT 2005 | Ray
We have switched from Uniscam due to support issues and their ablity to come out with a new USABLE version. We have been running it for close to 2 years now and we have been extremely happy with its performance and their support. Version 6.0 which
Electronics Forum | Wed Jun 01 09:39:15 EDT 2005 | George Truitt
Circuitcam and Checkpoint = �YOU GET WHAT YOU PAY FOR� It was 1 hour from the time I received the software until the time I was using it. I compared 2 Bill of materials (1200 placements topside 274 bottom side) due to rev changes, created a visual a
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
.gif)
winsouce.jpg)
