Electronics Forum | Thu Apr 29 10:35:31 EDT 2004 | dougt
Start with a load cell (force sensor), you will need one that can handle the force range you will be placing. Someone please correct me on this if I'm wrong but I seem to recall that placement force runs in the range of a couple hundred grams. Chec
Electronics Forum | Tue Apr 18 19:48:08 EDT 2006 | davef
There is no standard, nor should there be [because the IPC standards should be aimed at describing results, not the path used to reach the results]. So, your printer equipment supplier recommendations are a good starting point. Your "35-46 lbs-in"
Electronics Forum | Wed Sep 12 21:16:23 EDT 2001 | raton
The quip; All you can get! By the way, worthy answers above, especially Dave F getting a little tied up is good to see, he's always on the money otherwise. But seriously, watch for damage to other components. Example; thru hole's such as radial c
Electronics Forum | Fri Sep 07 14:09:57 EDT 2001 | aqueous
Hi Carol, Pressure requirements have changed over the past few years. In the recent past, aqueous cleaning systems relied on high flow, low pressure �flooding� techniques. 20 � 30 PSI pumped through large orifice nozzles. With ever increasing boa
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Wed Oct 02 13:59:11 EDT 2002 | davef
There are some excellent exhumation structures of high pressure and superhigh pressure metamorphic terranes in the Qinling-Dabie Mountain belt.
Electronics Forum | Wed Sep 01 06:38:37 EDT 2010 | grahamcooper22
Dear Leeg, Generally the faster your print speed the more down pressure you need on the blade to roll the paste and wipe the stencil surface clean. Pastes with higher viscosity need more pressure at slow and high print speeds. Too much pressure cause
Electronics Forum | Thu May 02 10:25:14 EDT 2013 | wahahasteven
we have a Specialty coating system (SCS) precisoncoat spray coating system. we are using an acrylic coating material with about 80cp viscosity. The spraying pressure is around 4-6 psi. The main issue is the finish looking of the board. If we apply hi
Electronics Forum | Fri Mar 02 12:46:32 EST 2001 | billschreiber
Hi Dale, Care should be taken when using compressed air to dry a stencil. Just as high-pressure sprays can bend delicate land mass areas between fine-pitch apertures, so can high-pressure air. In addition, OSHA frowns on the use of high-pressuer a
Electronics Forum | Mon Oct 22 13:21:12 EDT 2001 | Michael Konrad
Eric, The Kolb RB6D (and the RB5D) are not ultrasonic cleaners. They are high pressure spray cleaners. I would not recommend high pressure spray cleaners for misprinted assemblies with previously placed components (unless you don�t mind solder pas
We are your obsolete industrial product specialists. Our inventory includes VME, cPCI, ATCA, SBCs and much more industrial electronics
490 Schooley's Mountain Road
Hackettstown, NJ USA
Phone: 12018414027
