Electronics Forum | Fri May 15 18:13:35 EDT 1998 | Earl Moon
| | | Does the temp. profiles used to reflow double sided pcb's through a IR oven | | on FR4 board material have to be re-established if it is changed to | | polyimide? Boards will be baked out prior to assembly. | | any response would be most appr
Electronics Forum | Mon Feb 15 15:33:47 EST 1999 | Earl Moon
| Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc | I'm sure you know all the basic differences as Tg, X, Y, and Z expansi
Electronics Forum | Wed Oct 25 12:24:02 EDT 2000 | Philip
Hi Chris! I hope this will help you! The CBGA uses an array of high melting point solder spheres(Sn10/Pb90) to connect its ceramic chip carrier to an epoxy glass (FR4) PCB using eutectic (Sn63/Pb37) solder joints at both ceramic and card inter
Electronics Forum | Sat Oct 02 20:19:19 EDT 1999 | John Dwinell
| | I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Ir
| 1 |
.png)
winsouce.jpg)
