Electronics Forum | Thu May 13 14:41:17 EDT 1999 | Michael N.
I need some pics or documentation on how a finish soldered joint looks like for SMT component. I have various people who supposedly says has knowledge with High Temp says my joint could look better. The joint looks shiny and great except for a grainy
Electronics Forum | Thu Jan 31 06:38:55 EST 2008 | cobar
Wave too high,pot temp to high set to 245�C. Solder level too low.
Electronics Forum | Mon Jul 01 16:34:46 EDT 2013 | wpierowski
So that is common when the temp on the wash is high? The temp was adjusted for a flux that required a higher temp. How much of an issue is this tin oxide?
Electronics Forum | Fri Nov 03 13:48:39 EST 2006 | monty
I have a BTU Reflow 8 stage (PCDIU software) oven. The max temp. that it will allow is 270 degrees. I am trying to use a High Temp solder paste and the profile states that I must go between 260 and 270 degrees. My question is, is there a way to incre
Electronics Forum | Fri Dec 22 12:17:02 EST 2000 | vickij
Hi! Has anyone out there ever tried to use a high-temp and a low-temp solder paste on a double-sided board without using an adhesive? (Populate the bottom side with the high temp paste, reflow, turn it over, then run the top side). I looked in the
Electronics Forum | Wed Aug 03 11:08:24 EDT 2005 | PWH
We use the following stuff from "Biral USA": BIO30 Synthetic High Temp Oil � Chain Oilers NMG-400G � No melt grease - miter gears/lead screws AS500ML � Anti-size spray - lead screws, drive sprockets, rail support L-brackets It seems to work good
Electronics Forum | Wed May 03 17:40:06 EDT 2000 | Steve B.
Does any one you High temp past for bottom side surface mount components instead of using adhesive. We are having components falling off be for we wave, the problem is that we need do a lot of thru-hole assembly before waving. Thanks for your help.
Electronics Forum | Wed May 03 21:12:13 EDT 2000 | Dave F
Steve: We talked about hi temp solders for a different application recently. Lookit: High temperature solder paste for gold plated MCMs - Tuan Bui 13:43:06 01/26/2000 Good luck Dave F
Electronics Forum | Fri Nov 22 08:59:49 EST 2002 | ksfacinelli
I would have to agree with the to high temp being a real problem. I have seen this with the WS-609 alpha paste. If you run it up to high in temp. The joints appear to be cold but they are really just over fried.....definitely try reducing temperat
Electronics Forum | Wed Aug 09 08:59:52 EDT 2006 | zanolli
I agree with verifing this part is even high temp reflow compatible. The age of the original dwg release, 1986, and as there is no mention of high temp reflow compatibility, only a mat'l call out of nylon, leads me to think it is not.
