Electronics Forum | Mon Oct 21 14:06:28 EDT 2002 | slthomas
Brian, Before the change, the default setting was the section you were accessing the search engine from, i.e., if you were in Forums, it defaulted to searching the forums. Is that something that can be returned? Thanks......
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Mon Aug 20 07:31:26 EDT 2007 | dilogic
We have GSM1 running on USOS V1.4.14. Is there a way to change default light levels for PEC (down looking camera) during feeder teach? Whatever I tried, it is always set to some default level... - Dejan
Electronics Forum | Wed Oct 27 09:02:46 EDT 2004 | Tarheel
Does anyone have programming experience with CR Technologies RTI 6250 AOI ? They are out of business so support and parts are hard to find. I can change the default search area and the default illumination values but the changes I make are gone when
Electronics Forum | Thu Dec 16 14:50:49 EST 2010 | rway
What Derek means is, you will have to train new templates from time to time, something you have to do with every AOI. Because there is no established method for marking parts, these markings can change. For instance, the text on chip resistors coul
Electronics Forum | Thu Mar 24 16:46:29 EDT 2016 | tombstonesmt
The recognition system uses a image histogram for the lead tip check. So, perhaps you were scanning the area from the lead edge to .1-.2 towards the body of your QFP and not fulfilling the required pixel count for that area; increasing it allowed yo
Electronics Forum | Fri Dec 16 17:48:43 EST 2022 | kumarb
Hi. May I ask the factory default password used on the Ekra X4 printer for the PCB parameter changes? Believe it is some permutation of '4113' or similar. We had an accident recently with a drunk driver run through our building. In the process, lo
Electronics Forum | Wed Jun 24 15:36:58 EDT 2020 | aveazey
Do you know which menu this is under? We had tried changing the X,Y Location in the Camera configuration but the changes didn't seem to actually change anything. We would power cycle the machine every time after changing the config file. We also trie
Electronics Forum | Tue Jul 23 07:55:24 EDT 2019 | ashray
how can I change the language in MPM up 2000? the machine has a default language set to german I wanted to know if it can be changed to English. I tried in BIOS there is no option to do that. Please guide me on this.
Electronics Forum | Thu Jul 25 09:56:39 EDT 2019 | ashray
how can I change the language in MPM up 2000? the machine has a default language set to german I wanted to know if it can be changed to English. I tried in BIOS there is no option to do that. Please guide me on this.
