Electronics Forum | Wed Jun 15 22:27:40 EDT 2011 | pkamath2
Hello, My company recently installed a Positive Displacement Pump on a GSM Pick @ Place machine for dispensing chipbonder (loctite 3621) dots before mounting chip components. The head uses Universal stand nozzles (single port-small dot, dual port 0
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
Electronics Forum | Thu Jul 20 15:08:53 EDT 2000 | Bob Willis
Yes no problem here it is in a nut shell. The sponsor of my CD ROM on this process was Loctite who specifically developed a glue for the process to cure in less than 10seconds. Have a word with these guys they may even have a few CDs. PROCESS SEQUEN
| 1 |
.gif)
