Electronics Forum | Thu Jun 09 11:23:29 EDT 2022 | proceng1
If you would, post a photo of one of your WBH. I am assuming that you are talking about a fixture that holds an odd shaped board so that it fits into your machine.
Electronics Forum | Wed Mar 20 15:01:37 EDT 2024 | linux
Reboot usually does the trick, Reason for these fault, (1) Nozzle holder, the grippers are holding the nozzle too tight, stretch the spring slightly, (2) shaft is sticking, removed the head lubricate the shaft.(3) Nest not opening and closed within t
Electronics Forum | Thu Mar 28 19:36:21 EDT 2024 | linux
ensure the nozzle is inserting fulling into the nozzle holder. ensure shaft is lubricated, clean between the magnetics on the shaft. complete nozzle height calibration
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
Electronics Forum | Fri Dec 28 16:42:04 EST 2001 | johnthor
While we have nowhere near the volume you do we have bent 2 A-14s in 3 years. One was definitely operator error in that a tape holder arm was left floating the other is unknown as this particular (ex)operator wouldn't admit to knowing the time of da
Electronics Forum | Fri Feb 08 08:00:48 EST 2002 | caldon
Yet Again Dave spills his pearls of wisdom. Dave is correct in the moisture content wood absorbs. I know we have all visited factories with wood board holders and such. I have actually seen wood carts with drag chains. Also, keep in mind static can b
Electronics Forum | Sat Oct 25 19:02:45 EDT 2003 | Gabriele
Main difference is the reel holder position and for sure the clamping pin location. Tape feeding system is different. Any way they cannot be compatible among them. Q type feeders must be used for MV Q-Type placer and K-type feeders must be used for M
Electronics Forum | Mon Mar 07 18:41:13 EST 2005 | jimmyb
--IE, Funny.--- I "remember" kinda, from the early CP6 years, things about the springs. The early Fuji springs had sharp ends, and if you spun the nozzle, prior to final attachment, the opposite way it could stick, and if it was spun the right way,
Electronics Forum | Wed Aug 29 00:13:24 EDT 2007 | slthomas
The two factories I've worked at that ran Radial Lead inserter/sequencers were both building their own products and we were able to specify our own panelization guidelines. One-half inch rectangular frame on all boards. Our universal workboard hold
Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and
