Electronics Forum | Mon Nov 11 11:28:32 EST 2002 | davef
Sand is not a great conductor, compared to copper. Never heard of using the stuff on RF boards. Our board fabricator uses Dupont CP100, now CP101, [or something like that cuse who's going to check?] when plugging via on cheap boards. Your board fa
Electronics Forum | Thu Sep 08 06:19:55 EDT 2005 | lupo
Hello, Could anyone provide some support concern issue with vertical fill of through hole solder. Our lead free wave soldering process is not capable to fill 100% (requirement of our customer)through hole. We made everything (DoE) - different amoun
Electronics Forum | Thu Apr 29 18:48:11 EDT 1999 | Kiet Dang
Hi, Did anyone experience a problem with electrically conductive silver filled epoxy is resistive due to galvanic reaction? I'm having this problem when attaching components to Ni plated housing while conducting an experiment to cost reduction for Au
Electronics Forum | Thu May 20 07:53:55 EDT 1999 | Chris Nuttall
| | We care currently running into problems during our plug via process: | | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.Thi
Electronics Forum | Thu Aug 06 12:49:41 EDT 1998 | justin medernach
| I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and the
Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Wed Dec 10 16:15:24 EST 2008 | terryl
on the front end in design, minimize the pth connections to ground planes. this takes alot of work by the pcb designer and the approval of the design engineer. connect maximum of 4 ground planes to pth, minimum 1 plane. use spoked connections. ev
Electronics Forum | Thu Dec 11 07:29:58 EST 2008 | jdumont
I have done a few studies on this issue here. As a result we have increased hole diameter on heavily ground planed pins to a min of .015" over the lead diameter as well as preheating the PCB when hand soldering. I have also had to order the upper pre
Electronics Forum | Tue Dec 16 16:49:22 EST 2008 | scottd3
We ran into this problem before, on all of our models. We never quite found out the reason, we do know that if the PCB is passed through a reflow oven that is extremely dirty with evaporated solder paste flux, it will make it extremely difficult (or
Electronics Forum | Mon May 14 12:44:08 EDT 2012 | tomgervascio
I am a user of an Ersa Versaflow 3/45. I was wondering if anyone could share some process pointers. I have a 0.125" multilayer PCB that I am having problems consistently achieving 75 percent hole fill on a mini-coax connector. The coax connector ha
winsouce.jpg)
