Electronics Forum | Thu Aug 09 07:53:16 EDT 2012 | davef
Allowable bow & twist: Together, both IPC-A-600G and IPC-6012B represent the core IPC documents for describing the acceptable and nonconforming conditions that are either externally or internally visible on finished printed boards. IPC-A-600G relies
Electronics Forum | Tue Aug 14 08:07:40 EDT 2018 | buckcho
Hello, I am not sure what you mean exactly. Lead length is something standard given from components supplier. Pretty much all new AOI machines can measure the length and height of most of the leads on a IC.
Electronics Forum | Sat Nov 18 21:20:58 EST 2006 | Fer
Dave, May I ask where did you find the 1.5%, or the goal of .005" (or .007") per inch? The IPC-A-600 bow and twist standard calls for a .75% based on the calculation of the test method TM-650, method 2.4.22, which calculates the percentage based on
Electronics Forum | Wed Dec 17 09:53:26 EST 2003 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require. If we can�t get proper hole fill after try
Electronics Forum | Tue Jul 19 18:05:31 EDT 2016 | davef
I'm not real clear on what you're looking to understand, but let me get things started ... IPC-A-610F - Acceptability of Electronic Assemblies, 7.3.3 Supported Holes – Wire/Lead Protrusion Minimum length: You need to be able to discern the compone
Electronics Forum | Thu Sep 12 20:17:59 EDT 2013 | action_101
Good ole contact cs-400. I worked at two different companies that had these machines, all I believe were E's except 1 C. One place had one and the other place had 4 of them. Dont take this personally, but thank god my current employer doesn't have a
Electronics Forum | Thu Sep 04 10:24:39 EDT 2003 | paulrm
The typical PIP process is incorporated into the surface mount process. This approach requires the following: The stencil will be designed so that the correct amount of solder paste can be printed onto the through-holes to form an acceptable joint
Electronics Forum | Wed Feb 07 14:57:18 EST 2007 | davef
The standard Metronelec Menisco ST 60 can not run a dip and look test for PTH parts. It is an optional feature on that machine.
Electronics Forum | Tue Oct 01 15:48:56 EDT 2002 | lysik
No problem. A standard stencil is OK. You want to print a half moon shape on each side of the hole. Make sure you print about X2 the size of your hole and make sure you keep the print in close to the hole. You want to print X2 the hole size as to hav
Electronics Forum | Thu Oct 03 04:04:10 EDT 2002 | Bob Willis
SMTNet has a video tape and interactive CD ROM on Intrusive Reflow Soldering that you may want to check out. In addition there are some free inspection standards for pin in hole printing, placement and soldering available at http://www.dpmo-monitori
winsouce.jpg)