Electronics Forum | Mon Feb 14 10:38:17 EST 2005 | pjc
Try TnD Service: http://www.tndservice.com/ Ask for Tom or Dennis.
Electronics Forum | Mon Feb 14 09:22:13 EST 2005 | vortex
Recently I have started refurbing my companies extremely neglected Hollis TDL wave solder machine. After doing a general cleaning, de-fluxing, and de-greasing I have all the mechanical components back in working order. What i am left with is the elec
Electronics Forum | Mon May 07 22:00:11 EDT 2007 | seb1970
what type of preheater does the novastar use and what temp. is it set on? I am also use to a hollis wave solder machine. Old and crude but works great.
Electronics Forum | Fri Jun 19 14:57:00 EDT 1998 | Chris Jackson
I am looking for alternate suppliers of Hollis wave solder fingers other than Speedline(Electrovert) The Model and S/N of the wave solder is Model 207944 Serial # F11132 Please let me know if you are a vendor or know of a vendor. Your help would be
Electronics Forum | Tue Jun 23 17:03:10 EDT 1998 | Ken Chase
Yes, New Era Technology, Inc. is a manufacturer of Titanium fingers for Hollis and Sensbee wave Solder machines, as well as a other products. give them a call @ (603)669-7971 for more info.
Electronics Forum | Mon Jun 22 21:46:33 EDT 1998 | Dave F
| I am looking for alternate suppliers of Hollis wave solder fingers other than Speedline(Electrovert) The Model and S/N of the wave solder is | Model 207944 | Serial # F11132 | Please let me know if you are a vendor or know of a vendor. Your help w
Electronics Forum | Mon May 07 11:25:21 EDT 2007 | colormaker
Flux foam is not affected by board or pallot. This wave is not the same as the hollis I used. The hollis wave flowed from middle to left and right side. This wave only flows to the left and its a very slow wave. Jerry
Electronics Forum | Mon May 07 22:28:17 EDT 2007 | colormaker
radiant heat. 137c The hollis was a great machine. The one I had the prehead wass on or off there was no setting. The pot temperature guage was brocken so I had to guess and manually turn the heater on and off. The whole machine was covered with 1 i
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
