Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Mon Jun 12 11:04:20 EDT 2017 | bobpan
So what your telling me is kind of vague. Does the machine home and go to the front left corner of the machine? If it does....this could be a quad align problem....meaning dirt on the lens or so-forth. You should watch the heads homing in the z-axi
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Wed Feb 13 18:13:58 EST 2019 | slthomas
I'm trying to visualize how that machine is laid out. Do they all rotate together, on a belt, so that there's only one sensor for the theta (R) home position?
Electronics Forum | Fri Jan 15 12:20:26 EST 2021 | proceng1
It sounds like the homing switch isn't being made when it zeros. Alpha 1 Technologies can probably help. 607-772-2900 That's who we call for VCD issues.
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Wed Jan 19 08:19:18 EST 2011 | tombstonesmt
I recently wrote a program on one of our > Pilarhouse Jade machines and receiving an error. > The machine has the feature of "Wave Height" that > I don't have enabled for a 2.5mm extended tip > nozzle. This is the only program that I haven't > u
