Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Sun Feb 09 19:16:22 EST 2014 | navworx
Was running production when the head just came to a stop, motor went off, error window said to home. Upon attempting to home, got message: G1T2 homing error; index mark not found. I've tried rebooting the machine, but this error still appears. Any
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if
Electronics Forum | Sat Jun 21 11:00:32 EDT 2008 | 1036
We recently bought an used MPM SPM screen printer. The system can not boot up correctly and terminates the program finally. During the computer booting up, I can see error massages "mouse could not be found", "abnormal program terminated", "trap 0".
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
