Electronics Forum | Thu Sep 23 14:39:10 EDT 2010 | markgray
What is the exact message on the screen?
Electronics Forum | Mon Sep 20 06:29:27 EDT 2010 | darrenleebs
i have an old contact 3av pick and place machine that has started to display placement head position errors. the machine seems to start working if you switch it on and leave it for a couple of hours to warm up. has anybody had simillar issues with th
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Thu Oct 20 15:44:16 EDT 2022 | smtusa
What about MY100? Its based on the same high speed hydra head just two of them. Do you not recommend those as well? Originally, I was looking at a MY9 before spending on a MY100dx. Certain things mydata do make it attractive but im a low mix, high
Electronics Forum | Tue Aug 07 04:30:21 EDT 2012 | haiae
Could every one out there help me to solve Homing's problem with Contact 3AVX machine? I can not finish homing my machine cause error message as follows: "Head 1 - max index pulse iterations reached" Many thanks,
Electronics Forum | Wed Sep 25 16:08:47 EDT 2013 | nophsem
The game doesn't end, bobpan! When I changed SRX boards, turn on the machine and doesn't indicates Motor error #5 and head initialize at home. I upload a program, I put the PCB to start, then RUN and head stay paralyzed halfway between HOME and PCB,
Electronics Forum | Fri Mar 22 13:32:15 EDT 2019 | kahrpr
all the motors on the head are the same just the connecting cable are different length. the motors have a home position for the zero pulse that home position has to match when the flag passes through the homing sensor all servos have a home position
