Electronics Forum | Wed Nov 29 10:48:37 EST 2006 | bas Rottier
Hello, I'm looking for a protocol description of the SMPI interface (we would like to connect a SMPI machine to a SMEMA machine). Does anybody have description of signals (electrically) + waveforms + pin-layout + connectortype? THanks Regards bas.r
Electronics Forum | Wed Nov 29 20:35:47 EST 2006 | davef
Fine SMTnet Archives are amazing. Look here: http://www.smtnet.com/Forums/index.cfm/fuseaction/view_thread/CFApp/1/Thread_ID/6759
Electronics Forum | Thu Mar 12 01:29:53 EDT 2009 | mika
Hi everybody, Can anybody out there help me with this? I have a Jot conveour with SMEMA interface and and I need to "hook up" this to a Fuji conveour (CP6). The electrical drawings of the SMEMA I alreday have (IPC-SMEMA-9851), but I am hoping for a
Electronics Forum | Thu Mar 12 10:09:22 EDT 2009 | smellew
Mika, Is the Jot on the input side or output Regards Llew
Electronics Forum | Tue Mar 17 16:35:50 EDT 2009 | gregf912
Try switching pins 1 and 2 on the smema cable going to the CP6 machine. Fuji needs contact close then open to send/recieve boards.
Electronics Forum | Tue Mar 17 19:46:41 EDT 2009 | dman97
Hi Mika, Why not just splice into the existing 2 pin connector on the beginning or end of the CP conveyors? See attached picture...
Electronics Forum | Mon Mar 12 10:31:30 EDT 2007 | vickt
Universal does have a closed loop Traceability system (down to ref ID, per circuit if desired) that has enabled customers to gain FDA, and Military certification. Be aware that some "traceability" schemes do not access the actual machine code, and
Electronics Forum | Fri Aug 24 11:31:59 EDT 2001 | Stefan
Are you saying that the sensor is mounted onto the output conveyor of the glue machine and wired into the Onserter? If so ( weird, because the glue machine should have a SMEMA interface ), than you could mount the sensor on the input conveyor of the
Electronics Forum | Thu Jul 23 09:30:22 EDT 2009 | dekhead
It isn't clear if it was working and stopped, or if this is the first time you've tried to make it work. If this is first try, need to confirm cards and cables on DEK, and what interface is configured on UIC. I have SMEMA cards in stock if needed. P
Electronics Forum | Mon Jul 20 23:06:49 EDT 2009 | mika
10 or even up from a UIC conveyor of the old model - probably SMPI is the connector from UIC fully loaded, then full SMPI, but not all of them are used. Just Good board, bad Board, send, receive acknowledge. It is possible to convert this into SMEMA.
.gif)
