Electronics Forum | Thu Oct 12 04:04:23 EDT 2006 | odedkal
hello everybody ! does anybody have an experience with the hover davis feeders for siplace machines ? I am interested mainly in the triple feeder. is it better or easier to use than the original ? (siemens) any replies will be wellcomed, thanks o.k.
Electronics Forum | Thu Oct 12 12:51:39 EDT 2006 | john_smith
Hey Brian how are you doing? We also have one of these feeders and it works great! The best feature is the being able to reverse the feed wheel to backfeed parts. Just talked to the guys at Hover-Davis yesterday and they have had feeders in service
Electronics Forum | Thu Oct 12 08:22:44 EDT 2006 | stockley
We have one of the triples, it advances much more smoothly than the Siemens feeder and is easier to load. It is a well designed feeder, the drive mechanism uses some kind of plastic gears - but we haven't had it long enough to know if how well they w
Electronics Forum | Thu Jul 25 09:27:57 EDT 2013 | chris_flex
We are using some Hover Davis POD 600 at our site for label-placement. Since the feeder is no longer produced by hover davis , it`s always harder to get spares for those label-feeders. The supplier for this feeder-type in europe was pb-tec in germany
Electronics Forum | Thu Feb 03 13:40:35 EST 2005 | cyber_wolf
Has anyone ever had problems with Hover Davis feeders blowing up IC's on the main board of the MFU's ?
Electronics Forum | Mon Dec 03 13:10:06 EST 2007 | mulder0990
Does anyone know of any third party parts suppliers for Hover-Davis MPF and QF/QP Feeders?
Electronics Forum | Thu Jun 15 22:03:32 EDT 2006 | Frank
You are correct, the Hover Davis label feeder works on 'un-punched' flat carrier. Get a sample of your dots on the tape and send it to Hover Davis to see if their feeder will work for you. The Hover Davis feeder will peel the dot off of the tape so
Electronics Forum | Mon Sep 23 17:53:01 EDT 2002 | steveb
We have both Panasonic MPA3 56mm feeders and Hover-Davis 56mm feeders. You can go wider than this if you need, we also have a 72mm Hover-Davis feeder. You are correct in stating you will need to base plate for the Hover Davis feeders to work. We h
Electronics Forum | Fri Jan 26 21:47:18 EST 2001 | Ash Seawright
I noticed that you use a GSM. We have many GSM and a few Hover-Davis feeders available. If you are interested please contact me by e-mail at ash.seawright@lakota.com or by telephone at 281-356-7440. Thank You
Electronics Forum | Thu Mar 04 22:37:58 EST 1999 | Larry Johnson
Does anyone out there have any information on this new "Fuji Motor Feeder" Price and how it compares to Hover-Davis. I should specify feeders for an Fuji IP-3. Any information would be great. Thanks Larry
winsouce.jpg)
.gif)
