Electronics Forum | Fri Jul 11 11:48:51 EDT 2008 | ehess
What is the process for calibrating a soldering iron and/or station? What tools are needed, and how do i go about it? Thanks
Electronics Forum | Mon Jul 14 10:17:27 EDT 2008 | dwelch123
Ed,,You need a temp gauge to verify tip temp and if it's a digital control iron and it's off usually just junk it. If dial control you can loosen knob and adjust to reading.If you need to know type of gauge and manufacturer drop me a line
Electronics Forum | Mon Jul 14 11:33:35 EDT 2008 | stepheniii
It depends on the type of iron. Some of ours have a little plug you pull out that exposes a pot that you tweak to make the temperature of the tip the same as the reading. Others can't be adjusted and the heating element must be replaced if they don't
Electronics Forum | Tue Jul 14 13:20:13 EDT 2020 | tomdegas
I have a MY12 running TPS 2.8.1 and I need to know how to calibrate the X wagon Visin system. The machine is off in the Y direction after I removed and replaced the camera.
Electronics Forum | Thu Oct 04 14:38:00 EDT 2018 | babe7362000
Thanks I will try to calibrate again.
Electronics Forum | Fri Oct 05 08:46:19 EDT 2018 | babe7362000
I was unable to calibrate the Brightness step. The Pot was adjusted but would not brighten any further than 42. Im thinking I will need a new board or if someone knows what LED part number is used? Any information would be great. Thanks
Electronics Forum | Thu Sep 27 10:13:31 EDT 2018 | dontfeedphils
This should help out. You should have a fairly large calibration plate to use during this process as well.
Electronics Forum | Mon Aug 05 03:59:01 EDT 2024 | hardy
Hi， You can sent your e-mail to me.I can sent manual to you
Electronics Forum | Wed Jan 06 09:14:19 EST 2010 | jeffreyj
tpappano - Heh! Well, in the beginning there's going to be money flying INTO it... We decided the smartest thing to do was place a "help wanted" ad on craigslist for a Quad tech. One that lives in the area responded so we are going to hire him for a
Electronics Forum | Wed Nov 04 11:35:01 EST 2009 | dilogic
1. can you load cut tape onto the feeders, or only reels? You can, but you have to use cover tape extender (pretty cheap, though) >2. how about parts on trays (like Atmel AVRs in the QFP package)? You need tray feeder. But you can "make" your own
