Electronics Forum | Sat May 18 15:19:55 EDT 2013 | isd_jwendell
OK, I've now read all of the documents you referenced. The problem still remains regarding the thermal vias and how to minimize scavenging. All the docs acknowledge top and bottom tenting, and it's problems. TI says don't do it. Plugging is usually n
Electronics Forum | Wed Aug 24 21:57:45 EDT 2005 | adeline_ko
The blistering is around the plugging via. I can forward you the pic. For the plugging process, I'm not too sure how they plug. What is the correct practise for the plugging via. Now, what they did is. They will do a tenting process for both side.
Electronics Forum | Mon Sep 28 19:07:47 EDT 1998 | Steve Gregory
| I have had some field failures returned recently, the boards had flux contamination under the components in a sensitive area, Nothing really visible until the component was removed, and the board had no evidence of rework of any type. Is it poss
Electronics Forum | Wed Nov 30 12:44:54 EST 2005 | ppwlee
Dave, Do you know if such thermal transfer study with CB-100 (or equivalent) is available for review? My customer is pursuing this option and I am curious on how much improvement I would see by specifying a conductive via fill on the board. Rgds, P
Electronics Forum | Tue Dec 14 22:17:33 EST 1999 | Dave F
Armin: How ya doin� bud? CK gives good advice, but I'd like to take a bit of a different angle. Q1. For 0.7 mm (0.027in) diameter hole for vias, what�s the minimum annular ring for this hole diameter? Depends on what you�re trying to do. For in
Electronics Forum | Tue Sep 25 14:08:59 EDT 2001 | davef
Oooo, the solder on the pad and PGA ball is flowing during reflow down the via to the secondary side? Why didn�t you say so?? ;-) Why would you expect that gravity and capillary action wouldn�t force solder to flow down the solder plated via to the
Electronics Forum | Mon Feb 26 20:02:42 EST 2001 | davef
First, I don�t understand why your board fabricator can�t do a good job plugging your vias. Additionally, when you consider that they forgot to plug the first batch of boards, it makes me wonder if they are desirable as a supplier. Generally, we us
Electronics Forum | Thu Jun 04 08:32:21 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Wed Aug 09 16:30:43 EDT 2000 | MarkS
Has anyone had (successful) experience placing testpoint vias under BGAs? We already have conventional vias, but we're contemplating converting them into testpoints (probably by enlarging the bottom-side copper diameter to .036" and opening the bott
Electronics Forum | Wed Mar 25 19:41:01 EST 1998 | Earl Moon
| We have successfully put .016" vias in .030" pads. | There is no drain off with .030" solder balls, since | the actual volume in the .002" depression is low. | We did notice random bubbles where, apparently, the | solder reflowed and trapped the a
