Electronics Forum | Wed Jul 22 05:54:41 EDT 2015 | langkeauto2015
Hi, Tsvetan, sorry for your bad experience for Chinese brand PNP machine. For your doubt, pls refer to my comment:) Our pnp machine is special for led tube, led panel, led strip, RGB strip, and led display screen PCB, and real working speed feedbacke
Electronics Forum | Wed Jul 22 07:20:12 EDT 2015 | spoiltforchoice
I'm not entirely sure that is accurate. The only people who want small 'desktop' machines are hobbyists/labs who are unable to accept the costs and time constraints placed upon them by a subcontractor and think they can do better themselves. Standalo
Electronics Forum | Sun Aug 31 16:16:37 EDT 2014 | spoiltforchoice
Andres, I think if you were to understand the process a little better you would realise the many many problems you would encounter building even very simple things using your method. Even 30 minutes watching Youtube videos of current machines might h
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Thu Jun 28 08:14:11 EDT 2001 | Stefan Witte
I visit customers on a contract base to get the machines in a status, that an operator can take over. These customers are usually small shops, who can not effort an engineer to set up the machines. I am not afraid of my job, if it does not require a
Electronics Forum | Thu Sep 12 16:17:07 EDT 2002 | soupatech
There seems to be less play in the pocket than with other parts i've loaded. I was assuming the large nozzle would work better but for reasons unknown to me it didn't. I also tried a 1mm and had parts all over the machine (can you say hand place 100+
Electronics Forum | Wed Dec 04 04:28:58 EST 2019 | oxygensmd
It seems there isn't right connection between solder and solder-legs. Maybe check that the LEDs get huminidity, have some oxidation on the legs, try different solder paste, check the reflow solder profile. On the photo I can not saw properly reflowe
Electronics Forum | Mon May 13 02:14:04 EDT 2019 | tsvetan
All these generalizations are non sense. What real cph you will receive depend on many factors: - paths optimization - what number of feeders are used - what number of nozzle changes has your job - how fast is the recognition for small and big part
Electronics Forum | Tue Jul 16 13:08:24 EDT 2013 | ericrr
I seem to of slipped into a mighty giant suction cup, and every day is the same. Now take yesterday as I was making a sample the start of run board, we have run many times. it got halfway placing diffused LED's 3216 (about 1207 size) then is stoppe
Electronics Forum | Wed Feb 26 13:23:40 EST 2020 | rgduval
I haven't used these clips, or this machine, so... But..in general, I'd use as large a nozzle as you can that fits the pick area of the clip. That should give you the best opportunity at lifting the clip. If the machine has a gripper nozzle (with
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
