Electronics Forum | Tue Jul 18 15:47:07 EDT 2006 | Mark
IPC610 training to help verify issues that might arise. Also, the opeators need to know part numbers and descriptions because that should be common knowledge when running a SMT line. Plus, with your comment "At our company they know how the pick&plac
Electronics Forum | Tue Jun 18 09:51:53 EDT 2013 | rway
If they're 1 1/2 years old, they are definitely aged parts. Either send them back for newer or widen your tolerances on the ICT to compensate. You are at the 3rd decade now (10,000 hours) and you will need to compensate for this. These parts are n
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
Electronics Forum | Thu Jun 13 08:32:24 EDT 2013 | rway
Have you verified the measurements on the bench with an LCR meter? Chances are you are experiencing aging with these ceramic caps. We have similar issues with X5R and X7R caps. You will see the effects of aging with returns from the field as well
Electronics Forum | Fri Jun 14 00:47:17 EDT 2013 | mun4o
Thanks , Reese.Yes , I check the capacitors with C-meter.When measured with C-meter , all capacitors are OK - +/-10% of the value. I can not underst?nd "Note: This is not a summation). Y5V -- -20% of nominal value, -part tolerance, -machine toleranc
Electronics Forum | Thu Mar 18 11:07:45 EDT 2010 | mun4o
hi, lately I have problem with smd leds.After reflow 2-4% of leds are broken.I think , that reason is bad storage of components, because in our stock the tape with leds have not Moisture Barrier Bags.My question is ,how you storage components, which
Electronics Forum | Tue Jul 18 11:32:40 EDT 2006 | Joris Groot koerkamp
I am wondering what skills operators need to run an smd line itself. At our company they know how the pick&place machine works (refill/ changover), but if there is a problem with wrong placed components they don't known what to do. Our managmenttea
Electronics Forum | Fri Mar 19 13:18:03 EDT 2010 | deanm
Regarding your question about buying equipment to vacuum seal the MBBs, according to the IPC/JEDEC standard, "Full air evacuation is not needed or recommended; light air evacuation will reduce the packaging bulk and enhance carton packing. Excessive
Electronics Forum | Fri Jun 14 13:47:21 EDT 2013 | rway
Chances are this is not a component failure. First, these are passive components with passive testing on the ICT. He may have guarding issues, but more information is required as has been stated. Are all capacitors with the same P/N failing in dif
Electronics Forum | Thu Mar 18 12:46:20 EDT 2010 | deanm
The standard J-STD-033B.1 addresses how to store moisture sensitive components. A dry box is a good, convenient way to store MSDs, but there are other methods to consider which are outlined in the standard. Are you sure that the problems are caused
