Electronics Forum | Mon Jan 21 06:58:41 EST 2019 | kiransahu
Without PCB layout, not much would get done. It is a ubiquitous need across industries; Industrial, consumer, military...Everywhere you look, there are chips soldered to PCBs to create a final product for the end customer. But where did we all learn
Electronics Forum | Sat Jun 02 13:57:30 EDT 2007 | rodrigo
Hi all, We have an MCS30 connected to a CP6 and CP4 smt machines. Every time we need to set up a job, the operator has to type the data at the MCS30 terminal. We already have this data in a Windows PC file. I saw a ethernet and several unused serial
Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Mon Apr 04 12:16:32 EDT 2005 | DasonC
We make a custom mini stencil to print the paste onto the QFN and flip over to load on the rework station. The mini-stencil was designed for SRT to pick up the QFN. Check BeamOn (stencil house) for detail. Good luck
Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm
Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe
Electronics Forum | Wed Apr 03 10:25:04 EDT 2013 | gregp
We all seem to have forgotten about cover tape peel force testers. GPD makes them as do others I suppose. I would ask the tape and reel house if they have a tester. If they don't I would consider using someone else. Otherwise as another poster s
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Sun Jul 15 20:10:09 EDT 2001 | Danial
What is the best method to repair Warped PCBA. Obviuosly twisting it back to make it flat would be a disasterous. The method that I've tried wold be mounting the assembled board to the flat holder with the clamp and bake them at 120 Deg C for about 4
Electronics Forum | Mon May 01 11:25:23 EDT 2006 | ???
Lighten up and get a little humor....Must be a tough life being so serious all the time.
.gif)
winsouce.jpg)