Electronics Forum | Fri Oct 20 14:13:32 EDT 2000 | DENNIS XIONG
Dear all, We have a PCB design mistake that causes exposed copper layers on the edges of breakaway locations. Although we fixed the design, but we already made a lot of boards plus many made before we found the problem. I wonder if any one have some
Electronics Forum | Thu Jan 29 05:13:35 EST 2015 | neeraj_iiser
how to solder manganin 0.05mm manganin wire to a copper plate
Electronics Forum | Fri Jan 30 00:41:04 EST 2015 | neeraj_iiser
Thanks a lot , my application is cryogenic in nature. I am trying to make a Sub-Angstrom resolution Thermal expansion sensor, whose components have been machined out of OHFC copper, and i needed to solder a manganin wire to one of the capcitor plates
Electronics Forum | Thu Jan 29 09:18:36 EST 2015 | davef
Nichrome, manganin, phosphor bronze etc are easy to solder ... the hard part is removing the corrosion * Manganin: 86% copper, 12% manganese, 2% nickel. Often, it's used in making cryogenic measurements, due to its low heat loss. * Select a flux for
Electronics Forum | Wed Dec 19 01:17:13 EST 2001 | ianchan
Hi Experts, I need help here, advice appreciated from all... Production is running a Lot of flex-circuit PCB, through the SMT line, with 0402 components. The flex-PCB is taped to FR4 support "pallets" when processing thru' the SMT P&P m/c. We use
Electronics Forum | Thu May 15 09:55:16 EDT 2014 | julianf
Tmo, Thanks for your reply. It gives good advise about how to perform tests. The type of strain gauges that I want to design are inside the PCB at various layers and I want to read the data during the press step. Do you know if these prefabricated
Electronics Forum | Fri May 16 05:17:13 EDT 2014 | julianf
Interesting. How did you connect the gauges in the press? Our press only has connections for thermocouples. But in essence, it's only a wire and an electical output. If you placed these prefabricated gauges on top and on the bottom surface, weren't
Electronics Forum | Thu Nov 03 04:31:21 EST 2005 | arnold
davef, how can you convince me that 100Sn dissolved copper much faster?
Electronics Forum | Wed May 14 13:31:22 EDT 2014 | taiji
You should look in to this document: IPC/JEDEC-9704A Printed Circuit Assembly Strain Gage Test Guideline Regards
Electronics Forum | Thu May 15 17:34:17 EDT 2014 | taiji
I always made tests with gauges on top or bottom surface of the PCB, before, during and after the process that we wanted to check. But I never tried to do it on internal layers of PCB. Don't know if that is possible. Regards
.gif)
winsouce.jpg)