Electronics Forum | Wed Jun 18 08:57:45 EDT 2008 | more_sunshine
thanks for the post... but are you sure that the type of mask i mentioned is photoimageable and as i understood can be removed from desired places (pads/soldering areas) using uv and developer (which i don't know what material is it). and also the
Electronics Forum | Wed May 14 12:35:34 EDT 2008 | rgduval
Thanks, Chunks. That's the one point of the experiment that we haven't tried yet. Though, we came to the same conclusion just yesterday. Dave, so far, the most help we've gotten was from the paste manufacturer. I've involved the board house, but
Electronics Forum | Thu May 26 08:52:42 EDT 2011 | davef
Phil Zarrow wrote a useful paper that could help in evaluating paste. Here read it ... Evaluating Solder Paste � Not An Option Contributed by Phil Zarrow of ITM an Independent SMT consulting firm With soldering being the dominant source of assembly
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Thu Aug 10 13:16:17 EDT 2000 | Bob Willis
Here is some thing that I wrote a while back on solder beading. First what is a Solder Bead? The term solder bead is used to differentiate it from solder balls. A solder bead is a solder ball but its location is normally constant unlike solder bal
Electronics Forum | Wed Jul 09 04:57:11 EDT 2003 | Matt Kehoe
Our company applies solid solder to surface mount lands. While processing a micro BGA design we had some pads fall off, peel, whatever you might call it, from the surface of the board when touched "GENTLY" with the tip of a blade to remove a small s
Electronics Forum | Wed Jan 06 23:49:48 EST 1999 | Chris G.
| Hey All you Einsteins out there!! | | I gotta' problem...('course you do Steve, or you wouldn't be bugging the TechNet now would you?) I had a phone call from a acquaintance of mine wanting to bring two prototype boards over to rework a BGA socket
Electronics Forum | Tue Mar 09 07:51:12 EST 2004 | Bryan
Hello everyone: 1.I use Kester R244 63/37 solder paste. 2.Stencil thickness 6 mil. 3.Springdale Chipset. 4.PCB finish:HASL 5.Profile:Peak temp.:210~220C,time above 183C:60~90 seconds,time between 150~183C 60~90 seconds. 6.Reflow oven:Heller 1800 Voi
Electronics Forum | Wed Jan 06 23:01:48 EST 1999 | Dave F
| | Youse: This is SMTnet Steve. Sacrifice the socket. By the time you finish putzing-around removing the balls to get the socket off the board, replacing the lifted pads on the board, and reballing the socket; you've burnt the $100 that the socke
Electronics Forum | Wed Jan 06 21:56:37 EST 1999 | Steve Gregory
| Youse: This is SMTnet Steve. Sacrifice the socket. By the time you finish putzing-around removing the balls to get the socket off the board, replacing the lifted pads on the board, and reballing the socket; you've burnt the $100 that the socket
